2. Put the liquid medicine into the atomizing tank, dilute it to 30-50ml, tighten the tank cover, put the atomizing tank into the water tank, and cover the water tank cover tightly.
3. Turn on the power and turn on the power switch. The red indicator light will light up. Preheat for about 3 minutes before turning on the atomization switch. When the white light is on, the liquid medicine will be sprayed as a mist.
4. When inhaling, cover the mask on the nose and mouth, and open it when exhaling.
5. The general use time is 15-20 minutes. After the treatment, turn off the atomizer first, and then turn off the power switch, otherwise the electron tube will be easily damaged and the water in the sink will be poured out.
Matters needing attention when using medical atomizer:
1. Encourage patients to use masks for atomization, and don't bite their mouths (to prevent exhaled air from entering the atomizer and rusting the internal parts of the atomizer).
2. Add enough distilled water to the sink before starting every time. Check whether the diaphragm at the bottom of the medicine cup leaks water, so as to prevent the waste caused by the liquid medicine entering the water, which will corrode the wafer.
3. After each use, completely drain the water in the sink, dry the atomizer, and dry the wafer with a soft cloth. If there is scale on the wafer, soak it in the special cleaning solution for the wafer for 3 -5 minutes, and then dry it in the air to prolong the service life.
4. Do not use benzene, thinner and flammable chemicals to clean the product.
5. Do not carry or store this product when there is liquid medicine in the liquid medicine bottle.
Reference source;