1. First, open a CAD drawing, as shown in the figure below.
2. Secondly, after completing the above steps, find the page setup manager under the output menu, and then click to open the following interface. This is the page setup that needs to be used when creating a layout. It is suggested to modify "Layout 1" directly, as shown in the following figure.
3. Then, after completing the above steps, click Modify to open the following page. Make the settings according to the figure below, and then click OK. Note: If you have other requirements, you can choose according to the page prompts, as shown below.
4. Then, after completing the above steps, return to the next page and click the "Close" button, as shown in the following figure.
5. Then, after completing the above steps, click the Layout tab. Generally, when creating a new drawing, there are two layouts. You can modify these two layouts directly, or you can delete them and create a new layout. Take modification as an example. After clicking, the following figure will appear.
6. Then, after completing the above steps, enter the layout page. If there is a viewport in the layout, please select the viewport, enter e, press enter, and then delete, as shown in the following figure.
7. Then, after completing the above steps, switch to the layout menu and add a rectangular viewport, as shown in the figure below.
8. Then, after completing the above steps, the option of "Create Viewport" appears, as shown in the following figure.
9. Then, enter f directly and press enter, as shown in the figure below.
10. Then, after completing the above steps, enter z in the viewport and press Enter. See command options, as shown below. Enter w and press enter. Select the first drawing, and the drawing 1 will automatically fill the viewport. Double-click the outside of the viewport to exit the editing viewport and set the page as shown below.
1 1. Finally, after completing the above steps, select the viewport boundary line, and then place the boundary line on the non-printing layer. Click Preview under the Output menu. The effect after preview is as follows. At this point, the layout is created.