2. Apply UV shadowless glue on one side, close both sides, and illuminate with ultraviolet lamp or high-pressure mercury lamp with appropriate wavelength (generally 365 nm-400 nm) and energy to ensure that the light can really penetrate the bonding part;

3. It is suggested that the residual glue on the workpiece should be removed when the initial positioning is carried out for about 6 seconds, and then re-irradiated until it is completely cured;

4. The curing time varies according to different preparation materials, adhesive layer thickness and ultraviolet intensity. It is suggested that users buy an ultraviolet intensity tester and do a light intensity test before bonding to reduce the rejection rate;

5. The air temperature also has a little influence on the activity of the adhesive, and the curing time should be appropriately extended when the air temperature is low;

6. When operating, don't forcibly squeeze and repeatedly rub the materials to be bonded. It is recommended to use a fixed tool;

7, plastic bonding, should consider the content of ultraviolet absorbent in plastic, too high content will seriously affect the ultraviolet transmittance, which also has a significant impact on the curing efficiency of glue, and even lead to the glue can not be cured;

8. Low viscosity products are recommended for large area bonding. If possible, it is best to buy vacuum equipment and stick it in a vacuum environment to remove bubbles and improve the yield;

9. The above description is for reference only, and the specific operation needs the customer to make appropriate adjustments according to the specific situation.