1 First, we cut the packing tape. The length of the tape is cut according to the size of the basket. Six strips on each side are about 85cm long, and the number is twelve. Then tear the packaging tape into three strips. We should be careful when we open the door. Don't tear it in a hurry It's ugly when it's about to be torn. Be sure to tear them evenly.

2. When the back is torn, we start to cross weave, leaving a hole like one centimeter in the middle, and then start to weave three-sided tapes. If two pieces are woven together, they can be cross-woven without overlapping.

It's almost time to knit up. Tighten both pieces at the same time, and then continue to knit. If the torn tape is not long enough, you can continue to join it and knit it again. It's almost time. We can continue with a circle of wire. Finally, you're almost ready to shut up and put on your feet.

4. First weave the bottom of the basket. Just put a few strips vertically to the length you want, and then put the horizontal strips according to the above method to arrange the horizontal strips to the width you want. Start knitting the four sides of the basket. Fold the remaining strips at the bottom to make them stand up. Then draw a circle around them, with adjacent vertical bars on top of each other.

5. If one can't make a full turn, you can take the other one and turn it again, but you must choose to connect it under the vertical bar, so that the pressure will not stand out. Just weave it to the height you want. Fold the excess part down, then insert it into the hole of the woven part and press the end.