Take a small float and eat about 1 g of lead. Just put on the No.4 sleeve, adjust the hook without hanging things to the level, and then push it up slowly and float it on the water. We adjust the level of water, so this is "finding the bottom carefully" in real fishing, that is, setting the fishing eyes, just show a few if you want to catch a few eyes.

If the diameter of the vertical float is thin and the throwing distance is far away, it is very fastidious about eyesight. If the wind blows, the water waves and the float rises and falls in the water, it is even more difficult to observe. In order to solve this problem, it is an effective way to thicken the drift tail. However, because of the different diameters of the thickened part of the drift tail and the non-thickened part of the drift tail, the drift eye is easy to change when adjusting the drift.

In fact, this problem is very easy to solve. Take the three-mesh floating as an example. As long as you subtract the bold mesh number when adjusting the mesh and fishing, you can accurately complete the floating. The principle is very simple. The reason for buoyancy is that after the object enters the water, the water repels the object. In other words, if it does not enter the water, it will not produce buoyancy. The bold part has little effect on the overall weight of the float.

Web page link

Therefore, when adjusting the drift, as long as the bold part of the drift tail is not allowed to enter the water, that is, when adjusting the eyes and fishing the eyes, it is enough to add the bold mesh number. Take the two eyes of semi-water float adjustment and leveling water fishing as an example. Using the float without thickening the tail, it only takes two steps to complete the float adjustment. The first step is to level the water. The second step is to hook the bait and push up the float. If the float is larger than one eye, that is, the hook touches the bottom. Continue to push up the float until the float is exposed.

The principle is still the same when the float tail is changed to a three-eye float with a thicker tail. The first step is to level the water, but the float above the water surface can't just be a float tip, but a bold three-eye float is exposed, and the part that is not thickened can be put into the water. For fishing purposes, the bait is still hooked, and then the float is pushed down. When the float is larger than four meshes, the hook touches the bottom, and when the float above the water reaches five meshes, the fishing is completed.

If you only look at the number of eyes, it is to adjust three to catch five, but subtract the bold three eyes, which is just to level the water fishing two eyes, and so on, using other fishing methods, the principle is the same.