The emergence of induction cookers allows people to cook delicious food even when there is no gas or gas. Induction cookers are needed in university dormitories, factory dormitories, rental houses without kitchens, etc.

There are many brands of induction cookers. When purchasing, most people will choose well-known brands for safety and long-term use.

Fujibako is a brand of induction cookers. After using Fujibao induction cookers for a period of time, various problems will occur, such as not checking the pot.

So, how to repair the Fujibao induction cooker without inspecting the pot? The following editor will give you a detailed introduction to the relevant knowledge.

Repair methods for Fujibao induction cooker that does not check the pot: 1. The induction cooker does not check the pot but there is a "click-click" sound.

1. First check the transformer to see if the "T" secondary is open circuit and whether the secondary resistance is within the normal value (60±5Ω).

If it is outside this range, the transformer is faulty and can be replaced or repaired.

2. Is there any change in the color inside the induction cooker, white appearance, or slight leakage, etc.?

3. Check whether the chip of the induction cooker is working normally and whether there is a power output signal. If not, you need to replace the chip with a new one.

4. C14 and C15 are red polyester capacitors. If they leak electricity, the induction cooker will not check the pot. They should be disassembled and measured to see if there is any short circuit or leakage.

If so, you need to stop using it and replace it with a new induction cooker in time.

2. The induction cooker does not check the pot and there is no noise. 1. Check the voltage of the G-pole voltage regulator tube on the IGBT and see if the Z2 negative pole is at 0V. 0V is normal. If it is higher than 0V, Q6 and Q7 are damaged.

2. Check the capacitor of C2 to see if it is cracked, failed, etc.

3. Check the capacitor c18 to make sure it is open circuit.

4. Check the heating plate of the induction cooker to see if its voltage is normal and whether there is an open circuit.

5. If you cannot find the specific reason for the failure of the induction cooker not checking the pot, you can adjust the power of the potentiometer, try to reduce its power, and then see if the induction cooker still has the failure of not checking the pot.

How to repair a Fujibao induction cooker that does not check the pot? If the code "e0" appears during the operation of the Fujibao induction cooker, it means that it does not check the pot. You can use the above methods to repair and improve the condition of the induction cooker.

When servicing a Fujibao induction cooker without inspecting the pot, the power must be cut off. At the same time, people who do not understand circuits are best not to conduct servicing in person. The induction cooker should be entrusted to professionals for maintenance to avoid any accidents.

In addition, induction cookers are very cheap now. If it breaks down, it is better to buy a new one than to repair it.