Paper-cut materials for window grilles: red colored paper, students' books (large size), cardboard, pencil, eraser, watercolor pen (dark color), ruler, scissors and blades.

Fu window paper-cutting steps:

1, cut a square colored paper, draw the line inside with a pencil and ruler, pull up a corner and fold it diagonally, and fold the colored paper into a triangle.

2. Fold the acute angles on both sides of the triangle into a small triangle, and then fold the middle of the triangle into a smaller triangle.

Draw a pattern on the open end of the triangle with a pencil.

4. Cut the blank space of the pattern with scissors.

5. Measure the size of the middle square with a ruler, and draw a square with the same size on the notebook with the measured size. Attention; Choose a thinner book.

6. Write the blessing on the square with a pencil, and then outline the edge of the blessing with a pencil. Try to make the four sides of the word "Fu" close to the inner edge of the square.

7. Use a pencil and eraser to repeatedly modify the Chinese character Fu until the structure of the Chinese character Fu is standardized and symmetrical. Draw a blessing line with a dark watercolor pen, so that you can see the trace on the back of the paper, and then tear it off.

8. Spread the back of the colored paper upward, put a notebook under it, and then take another colored paper (choose the colored paper that can easily erase the pigment) or printing paper, and cover it with the back upward.

9. Cover the written page with the reverse side up. Adjust the position of the Fu character and the colored paper below, so that the four sides of the Fu character are aligned with the four sides of the colored paper.

10, forcibly draw the lines of Chinese characters with a ballpoint pen or other sharp hard objects (not too sharp, you can draw traces hard), thus leaving traces on the paper. Attention; Don't move the page, hold it down with your hands or heavy objects.

1 1. If you open other paper, you will see the trace of the word Fu printed on the colored paper. As shown in the picture, draw the connection part between the blessing and the pattern with a pencil. Try to associate the word "fu" with the patterns in several places.

12, the blade is broken in the middle, and cut off by half with scissors. Find a piece of cardboard and spread the colored paper upside down on the cardboard.

13. Draw the lines of colored paper with a blade, starting with the characters, and don't cut the seams. Finally, draw the inner lines and edges of the pattern. If you accidentally scratch the joint, you can cut a small piece of transparent tape and stick it on the back to remedy it.

14, carefully remove the crossed-out part, and the paper-cut of the blessing character will be done.