1. Press the function key or slider to select the "Hot Rice" function and press the "Start" key;
2. The rice cooker automatically enters the heat preservation process;
3. Keep the temperature for 30 minutes and turn the rice loose.
Extended data:
Matters needing attention
1, the automatic water adding electric steamer should check whether the water supply pressure meets the manufacturer's requirements, whether the water inlet valve is open and whether the drain valve is closed. Whether the drain valve of manual water injection electric steamer is closed.
2. Check whether the water level of the automatic water adding electric steamer is basically immersed in the electric heating tube, and whether the water supply of the artificial water adding electric steamer reaches the water level mark.
3, should close the door to avoid steam leakage, otherwise it is a waste of energy, and easy to cause operator burns.
4. When you open the door of the box after work, you should completely release the steam in the box to avoid scalding people.
5. When the electric steamer fails, because it is a metal shell, turn off the power first, and then check the failure. It is best to inform professionals to carry out maintenance to avoid danger.
6. After use, the water in the compartment should be drained to prevent the electric heating tube and metal surface of the electric steamer from aging due to moisture. Remove the dirt on the electric heating tube, so that the electric heating tube can conduct heat quickly and avoid overheating and burning out.
8. Clean the inner and outer surfaces of the electric steamer to keep the electric steamer clean and hygienic, but spraying and cleaning are not allowed, which will lead to damp, short circuit and even leakage of all electrical components.
9. When using an electric steamer with pressure, please set the size of the pressure valve at about 80 kPa, which is conducive to protecting the safety of operators. Do not leave the personnel during the operation, and if necessary, make sure to cut off the power supply when the personnel leave.