Tools/materials: a piece of flannel, a button, a needle and a thread.
1. First, cut the cloth into two pieces of the same size.
2. Then, take a piece of cloth and fold it from one end.
3. Fold it back to form an S-shape.
4. Fold back and forth repeatedly until all the belts are folded.
5. Thread the thread on the needle and tie a knot at last.
6. Thread a needle and thread through all the folds from the inside.
7. Then tighten the thread, and the ends of these small folds will spread out into the shape of half a flower. The thread will be reserved for the second half of the flower.
8. Another piece of cloth is folded into a repeated S-shape in the same way.
9. Pass the remaining thread through the second folded S-shaped cloth.
10. Tighten the thread, and the second piece of cloth forms half a flower. Sew the half flowers on both sides tightly together to form a flower.
1 1. Finally, sew a big button in the middle of the flower, and a beautiful the cloth flower will be made.
The practice of making snakes with handmade fabrics;
Materials: 4 wool strips, non-woven fabrics (green and blue), scissors, tape measure, hot melt glue gun, plastic eyes, red yarn or string (about 7.5cm long).
1. Twist one end of two wool tops together to form a long strip. Screw the other two wool strips together in the same way. Put these two long wool strips side by side and twist them into a thick wool strip.
2. As shown in the figure, cut a small strip with a width of 2 cm and a length of 10 cm from the green non-woven fabric and wrap it around the end of the fluff. Loosely winding cloth strips on velvet strips to form the tail of rattlesnake, and then pasting and fixing it.
3. Next, use a piece of cloth with a width of 2.5cm, a length of14cm, a width of 2.5cm and a length of 23cm to make two more rattlesnake bodies. However, this time, instead of directly winding the non-woven fabric strip on the velvet strip, roll it into a loose cloth roll first, and then pass the velvet strip through its center.
4. Next, roll 6 green cloth rolls and 7 blue cloth rolls with a width of 2.5 cm and a length of 30 cm, and thread them into the velvet strips alternately. Then wrap a large cloth roll with a piece of cloth with a width of 4.5 cm and a length of 32.5 cm, and use it as the head of the rattlesnake, thread it into the end of the velvet strip, and stick it and fix it.
5. Stick a round cloth on the rattlesnake's head. Then trim the wafer so that it is flush with the cloth roll.
6. Now make the tongue of the rattlesnake, tie a knot at the end of the red yarn or rope, and then stick the knot on the front of the rattlesnake's head. Trim the length of yarn and separate the rope.
7. Finally, put a plastic eye on each side of the head.