1, a core wire is needed. According to the actual situation, choose the wire type of 2 50cm, buckle, rhombic knot 1.8cm=0.2 wax wire of 2 70cm.

2. Fold the knitted buckle in half and tie two snake knots on the two steel wires of the knitted buckle to fix it.

3. The main body is made of two 1 70cm corn knot 0.45 wax thread, and the weaving method adopts 1 press 2, 2 press 3, 3 press 4, 4 press1to form a "Tian" grid.

4. Make this up.

5. Thread the core wire through "Tian Zige" and tighten it.

6, tighten this way, and in turn compile in this way.

7. When the length of the corn knot is 1 6cm, the length of the line will increase with each increase of1cm.

8. Turn off 0.2 wax thread and continue to weave corn knots to complete weaving, and pay attention to subtract 1 thread end from each weaving 1 loop.

9. The finished product drawing is concise and generous.

The specific method of tying knots on the four lines is as follows:

1, put four lines between your fingers and then square them.

2. Turn the blue line clockwise.

3. The green line draws a circle clockwise and crosses the blue circle.

4. Ink lines extend from the outside of the blue circle to the green circle.

5. The red line extends from the outside of the green circle to the blue circle.

6. As shown in the figure.

7. The chalk line passes through the blue circle from the outside and then enters the red circle.

8. Pink is red and green. The blue line crosses the blue line clockwise, and the red is over green, and the red is selected.

9. The green line passes through the green line clockwise, and the powder is pressed on the powder blue.

10, the blue line presses red and picks green clockwise, the green line presses blue and picks green clockwise, the green line presses blue and picks green clockwise, and the chalk line passes through the chalk line clockwise and goes out from the center around the bottom.

165438+