Methods 1: Toy cars were made from plastic bottles.
1, cleaning plastic bottles. Tear off the label on the bottle. Add detergent to hot water and let the bottle soak in it 10 minute. This will help clean label and remove residues and bacteria.
2. Punch two holes on both sides of the bottle. The axle should pass through the middle of the hole, so the corresponding holes should be flush.
3. Look for the material of the axle. Many things can be used to make axles, such as straws, sticks, toothpicks or wires removed from hangers. If you find something as long as a pencil, two are enough; If it is as short as a toothpick, you must prepare four.
4. Collect four bottle caps. Find four bottle caps to make wheels.
5. Paint the car body and wheels. You can paint the outside of the car body and wheels. It will be more convenient to spray paint before assembling the car.
6. Pass the shaft through the bottle. There can be two or four axles, depending on the material you choose. The long axis directly passes from one side of the bottle to the other side; Each hole has a short shaft, such as a toothpick.
7. Drill a hole in the middle of the bottle cap. Tie a knot in the rope, then put the rope into the bottle cap to make sure it is tied in the bottle cap, and finally tighten the bottle cap.
8. Cut off the top half of the bottle and make a windshield. Cut a rectangle or square on the top of the bottle with a sharp tool such as a utility knife. It is enough to cut three sides, because it will eventually fold. This way, when you open the windshield, it is facing the bottle mouth.
9. Drill a hole in the center of each of the four plastic bottle caps. You can use a drill or other sharp tools.
10. Put the wheel into the axle. Pass the axle through the hole just drilled in the bottle cap to see if the car can be laid flat. If the wheels are too big or too small, the car will not be able to move. The outside of the bottle cap will be more stable against the car body.
1 1. Pull the cart with a rope. If you don't want to pull with a rope, you can also push the cart.
Method 2: Make a car out of milk cartons.
1, four caps found. Make a hole in the middle of the bottle cap with a sharp tool such as art knife, scissors or knife. Bottle caps are used to make wheels.
2. Take two bamboo sticks and put them on the milk box. Cut the bamboo stick short, slightly longer than the width of the milk carton. Bamboo strips will be used to make axles. If you want the shaft to pass through the milk carton, you can drill two parallel holes on both sides of the carton.
3. Pass one end of the bamboo stick through the bottle cap. Make sure that the outside of the bottle cap faces the milk carton, which will help stabilize the car body. Apply glue to the place where the bamboo stick contacts the bottle. Wait until the glue dries before proceeding to the next step.
4. Put the straw on the bamboo stick. Pass the end of the bamboo stick through the straw, don't stick the wheel, and then cut the straw into a slightly shorter length than the bamboo stick. Putting a bamboo stick through the straw can make the wheel turn more smoothly.
5. Put the remaining wheels on the bamboo stick. If you poke a hole in the milk carton, first put the other end of the bamboo stick through the milk carton and then stick the wheel on it. So the axle is finished.
6. Stick the shaft horizontally on the milk box, and the shaft should be parallel to the wide side of the milk box.
7. Decorate the car. Decorate the milk box with colored paper, paint or marker, or cut the box into various shapes to make it more personalized.