1, the air support rod first pressed down, in a closed state, with a hand grip in the hand, close to the need to install the air support rod on that piece of wood (is to support the bed panel). Bed panels are generally made of two enough to become, one is fixed, one needs to be installed on the gas struts, in the intersection of the two boards close to the fixed piece in the bed of the vertical panels down to draw a vertical line.

2, so that after the closure of the end of the air support rod close to this vertical line, in the bed of the upper end of the support board flat, and then use a pencil in the air support rod need to be installed in the screws in the hole to make a mark.

3, with a hand drill in the marked holes, the air support rod is fixed to the bed on both sides of the support board (that is, on the bed legs).

4, install the bed panel, the end of the bed panel and the end of the gas strut rod flush, the same with a pencil through the gas strut screw holes in the panel to make a mark, and then hit the holes on the screws, do not be too tight, you can first two on both sides of the two on the live, the bed is repeatedly closed a few times, such as the bed is adjusted to the optimal state, in the other screws to fill in the several screws, tighten. This way the ribs frame gas struts are installed.