Material preparation: nail tools, phototherapy lamps, phototherapy glue including primer (also called adhesive), sealant, transparent extended adhesive paper holder, and gel water for gasket.

Procedure:

1. Clean the dead skin of fingers with nail tools, and cut the nails to 1-2MM.

2. Place the paper tray and adjust it. The contact point between nails and Z paper tray should be smooth and excessive, and pay attention to whether it is in close contact with fingers.

3. Apply the adhesive (primer) to the nail and irradiate it with a lamp for about 30 seconds.

4. Use transparent phototherapy nail polish, also known as transparent model cream, spread the nail polish on a paper plate and choose according to the required length. Then light it for about 30 seconds before going to the second floor. Depending on the situation, you can decide whether it is necessary to go to the third and fourth floors. It takes a little longer to light the last layer, usually about 2 minutes.

Note: Do not touch the skin on the edge of fingers with phototherapy glue, otherwise it will be easy to lift. If there is excess phototherapy glue flowing to the edge of your finger, you can gently scrape it off with your nails. The first coat should not be too thick. Make up slowly in the back.

5. After lighting the lamp, fix the shape. At the beginning, there must be many problems and strange shapes. Pick up your frustration, fix it slowly and make it look like a nail.

6. Apply sealant after repair. Sealants are usually very thin. Brush a layer on the finished nail, which can strengthen and brighten it. Then turn on the light for about 2 minutes. Dry and take it out. Wash it with detergent once and it's done.

Beginners, start with the simplest. You can change the color after you are familiar with the program, and you can also add a series of things such as painting flowers and setting diamonds. If you draw flowers, you can do them together in the fifth step. As long as you practice more, you can naturally master the laws of these things.

Monochrome crystal nail making program

1, disinfection.

2. Cut the shape of the front edge of the natural nail, and trim the front edge of the natural nail clean to prevent the gray front edge of the natural nail from being seen through the transparent nail, which will affect the appearance.

3. Push your finger skin.

4. Cut off excess finger skin.

5. Use 100 abrasive belt to polish the surface of the natural nail, master the polishing strength, and polish it back and forth along the natural nail, so as to avoid the natural nail from breaking.

6. Apply disinfectant and dry glue on the surface of natural nails, and don't touch the skin. In case of accidental contact with skin, immediately rinse with clean water for five to ten minutes.

7. Put it on a paper tray to make it closely connected with natural nails.

8. Take crystal nail polish (a mixture of nail polish solution and nail powder) and apply it to the front edge of the nail and smooth it. This operation is completed in four strokes.

9. Sandpaper the entire nail surface. 100, so that crystal nails can be connected with natural nails to get an approximate body.

10, coated with nutrient oil and polished.

1 1, coat with bright oil and finish.