The simplest and most accurate way for novices to pour goods in the warehouse. In life, I believe many friends have learned to drive more or less. There are many kinds of driving in general, and the difficulty may be warehousing, so we must master the methods. Below I have compiled the simplest and most accurate method for a novice to pour goods.

The simplest and most accurate method for beginners to transfer libraries 1 Tip 1: Look for reference points and lines after getting on the bus.

After getting on the bus, don't rush to start reversing, first adjust the seat to a fixed position in daily practice. We know that in the correct storage, we should kill the steering wheel to the right according to the reference point and line in time, and whether we can find the reference point and line accurately has a lot to do with the habit of fixing the seat position.

Tip 2: observe the distance between the car and the front warehouse line.

Pay attention to the distance between the car and the front garage line before getting on the bus. Generally speaking, the red line in the schematic diagram needs about 1.8-2 meters. This is because the distance is too large, which will increase the difficulty of reversing into the warehouse, while the distance is too small, which will easily cause the left front wheel of the car to sweep the garage line when it is killed on the right side.

When the distance is found inappropriate, it must be adjusted in time. The general method is to directly reverse the car for 6 or 7 meters, and adjust it to the left or right during driving in Xiangqian Che according to the distance.

Tip 3: Re-check the reference points and reference lines.

After the seat is adjusted, check the position of the rearview mirror. If there is no problem, you should look back at the position of the point and line you usually point to. Because the situation in the examination room is different from that in the driving school, you need to observe it again before reversing. There are many students who are not good at reversing when they get up. The reason is that I am not familiar with the examination room, so I miss the position of the points and lines that I should refer to at ordinary times.

Tip 4: Learn to turn to shunting.

Under normal circumstances, it is difficult for students to ensure that they can enter the warehouse smoothly without diversion every time they turn right when reversing, and it is inevitable that they will play late or early. If you play late, it will be difficult to get into the library. Therefore, it is suggested that students choose appropriate reference points and reference lines;

The timing of killing the right hand can be a little earlier, which often leads to the need to turn around and divert the car when reversing. Therefore, when practicing cars at ordinary times, it is the key to improve the success of reversing and warehousing to consciously create the situation of turning and shunting and master the skills of turning and shunting.

Tip 5: Accurately judge the distance between the car body and the corner of the garage.

Let's take reversing into the warehouse on the right as an example. When the right car is killed and continues to reverse into the warehouse, students need to look at the right rearview mirror to judge the distance between the car body and the corner of the warehouse. For freshmen who have no sense of car at all, one difficulty is that they often don't know how to judge according to the distance between the car body and the corner of the garage presented by the right rearview mirror.

There are roughly three situations when reversing into the warehouse. First, there is no need to adjust the distance between the car body and the corner of the garage (generally speaking, it is two fingers wide), second, the distance between the car body and the corner of the garage is too large, and third, the distance between the car body and the corner of the garage is too small. It is important to use the rearview mirror well. Only by judging whether the distance between the car body and the corner of the garage is appropriate according to the rearview mirror display can we decide the next step.

Operating requirements for reversing storage:

During the examination, vehicles are not allowed to stop on the way forward and backward. From the control line (body pressure control line) at one end of the road, it is poured into the garage for parking, then it goes out of the warehouse, passes through the control line at the other end, then it is poured into the garage for parking, and finally it goes forward and drives out of the garage.

Evaluation standard of reverse storage

A) Failing to follow the prescribed route and sequence, which is unqualified;

B) The car body does not conform to the requirements and is unqualified;

C) Not put into storage, unqualified;

D) Stop halfway (stop for more than 3 seconds), which is unqualified;

E) more than 4 minutes, unqualified.

Size of reversing storage (taking Santana as an example)

Library width = body width (excluding rearview mirror) plus 60cm.

Position length = body length plus 70cm.

Lane width = 65438+ 0.5 times of body length.

Distance from the garage to the control line = 65438+ 0.5 times the length of the car body.

The simplest and most accurate method for beginners to dump the library 2 The first skill: parking sideways.

I learned to park horizontally in the second exam, but when I really got on the road, there were cars in front of and behind a parking space, and sometimes there were no complete parking spaces. At this time, many people forgot how to back into the warehouse.

Faced with this situation, take the "I" parking space on the right side of the parking lane as an example. First drive the car parallel to the front car, the distance is 1- 1.5 meters, then aim the right rearview mirror at the B-pillar of the front car, and then start to turn the steering wheel to the right and reverse the car. When the car forms an angle of about 45 with the front car, turn the steering wheel to the left and reverse the car. Finally, after pouring into the parking space, stop according to the position of the rear wheel.

The second measure: 90 reverse warehousing.

This method of reverse order is the same as the exam of subject 2. First, control the distance between the car and the parking line at 1- 1.5m, then drive the car to a position parallel to the parking line and the rear of the first car next to it is in line, then fill the steering wheel to the left, then observe the two rearview mirrors to see whether the car is parallel to the parking lines on both sides or parallel to the cars on both sides, and then adjust the steering wheel according to the length of the rear of the car.

The third skill: oblique warehousing method

When there is a large open space in front of the parking space, find the parking space and drive the car forward. When the car body is about 1 m from the parking edge and the car body is 45 degrees from the parking space, turn the steering wheel back to the right in time, and then turn the steering wheel to the left.

Until the car body is parallel to the parking line or vehicles on both sides, adjust the position to stop. This method is simpler than reversing 90 and stopping sideways, but the disadvantage is that the area in front of the parking space is not suitable for this method.

The fourth measure: reverse according to the driver's auxiliary configuration that comes with the vehicle.

If the first three reversing skills are still difficult, then the last one will definitely not be difficult. At present, many cars have their own 360 panoramic images, which can display the road information around the car in real time on the central control screen in the car and mosaic it into a subsequent 360 bird's eye view, which is simply an "artifact" for novice drivers who lack "car sense";

For example, Mitsubishi Yige is equipped with advanced high-definition 360 panoramic images, which can observe the road conditions around Yige in 360 degrees without dead ends. Moreover, Yige also has a rear reversing radar and a reversing side early warning system, which can identify nearby cars and pedestrians when reversing. The combination of the three not only improves driving safety;

It also greatly reduces the difficulty for novice drivers to reverse. So novices go out with game songs, and relying on these three configurations, they can park their cars in the parking space by reversing slowly.

Novice's simplest and most accurate method of dumping the library 3. First, the steering wheel hits the dead center.

This is the most critical benchmark for reversing storage. If you can't find this point, it will be very troublesome to correct your body later. And it is likely to crush a corner of the library and cause it to close down. Learn to observe the left and right rearview mirrors and find the position of the lower edge of the rearview mirror and the end line of the library.

Second, return to the library on time.

When the car enters the garage, straighten the position of the car, adjust the opportunity, learn to observe the left and right rearview mirrors, make the left and right sideline of the garage parallel to the car body, and adjust the car body immediately. In this process, we must control the speed, slowly turn the steering wheel, and slowly adjust the body position to the middle. Turn the steering wheel to the wider side in the rearview mirror. Slightly adjust your body several times until the distance on both sides is equal, and then straighten your body.

Third, find a good parking spot.

Don't let the rear of the car touch the rear sideline, or it will fail. Use the relationship between the lower edges of the left and right rearview mirrors and the front edge of the garage to find the parking spot. Keep a good sitting posture and find the parking spot accurately. Be careful and have enough patience when operating. Learn to observe carefully and find the right starting point.

Tips: When taking the exam, you must remember to adjust the position of the seat and the position of the rearview mirror. Adjust the seat to a suitable position, find all the points through the rearview mirror, and complete the operation process of subject 2. Be patient throughout the exam, especially when reversing into the warehouse. You must make several minor adjustments and learn to repair the steering wheel.

Correction skills of steering wheel in reversing storage

My experience is that every time I turn the steering wheel at the starting line, I prefer to turn the steering wheel earlier and turn it back a little when the wheels are close to the corner of the warehouse as needed, because you may have to correct it if you turn the steering wheel ahead of time. If you don't turn the steering wheel for a long time, the wheel has already pressed to the corner of the warehouse (the left wheel of the right warehouse presses to the left corner, and the right wheel of the left warehouse presses to the right corner), you have no remedy. In particular, if you

Delay the steering wheel. If the wheels won't hit the corner of the garage, don't rush back to the steering wheel when the car body is parallel to the garage sideline, and then turn back to the steering wheel when the car body passes the garage center sideline.

Because this can ensure that the car body can be parked in the center of the garage without any major changes, it is particularly important to pay attention to that when the car body crosses the center line of the garage, it should quickly kill the steering wheel in the opposite direction, and then quickly return to the steering wheel when the car body is parallel. Otherwise, the front wheel of the car will hit the sideline.

When reversing into the warehouse, there is no absolute reference point for steering wheel calibration, that is, when the steering wheel is turned to the left, to the right and to the back. In fact, the general principle is that the steering wheel should turn from the wide side. )

The car is in the middle of the garage, parallel to the sideline. You need to use these flexibly, and remember not to memorize them. When you can master these things skillfully, the above points are not so absolute, because you can reverse the car into the warehouse by feeling 100%.