the toilet is blocked with shit, which is a way to clear it. Toilets are often seen in our daily life, because toilets are an indispensable part of our home environment, but toilets are easily blocked. Here are some tips to clear the toilet blocked by excrement.

the toilet is blocked with shit. Trick 1

First, the toilet is blocked with shit.

1. With regard to the trick that the toilet is blocked by excrement, this situation is generally easier to solve, and these blockages can generally be decomposed with hot water. First boil a pot of hot water and pour it into the toilet, then soften the blockage in the water pipe. Let them soak for a while, and when they are soft, you will see the blockage drain slowly, and then rinse them with large buckets of water several times. It can also be dredged with iron wire or special dredging tools, and it can also be solved.

2. if it is blocked by toothpicks, bones and other objects that are not easy to soak and decompose, this situation will be more troublesome. You can use the principle of pressure to find a longer plastic water pipe with one end connected to the tap water pipe and the other end stuffed into the toilet. Then, seal up the unwanted rags or clothes, and try to use a whole piece to prevent the cloth from being blocked more seriously after it is scattered. Then turn on the tap water, and use the pressure of water to knock out the hard objects and pick them up.

Second, the toilet is blocked by salt and baking soda

1. As for the method of using salt and baking soda to block the toilet, first prepare a cup of baking soda, an appropriate amount of hydrochloric acid and an appropriate amount of hot water. Pour the prepared baking soda into the blocked toilet. Try to fall in the lower part of the middle, not on the toilet wall. It will prevent insufficient quantity, difficult reaction and no effect.

2. after pouring the baking soda, pour the prepared hydrochloric acid into it, and pay attention when pouring. The role of hydrochloric acid is to react with baking soda to produce a large amount of carbon dioxide gas, increasing the pressure of the toilet. Another function is that hydrochloric acid is an acidic substance, which can react with some sticky paste on the toilet wall, so that the blockage loses part of its adhesion and is easier to be washed away.

3. after pouring baking soda and hydrochloric acid, quickly pour hot water. Boiling water can accelerate the reaction between baking soda and hydrochloric acid, and also soften some organic substances, such as fatty acids and oils. And the adhesive property is lost.

4. After the hot water is poured in, quickly cover the toilet lid to ensure that the sealing effect of the toilet is very good. If the sealing ring is dropped or not, it can be replaced with a humidified towel. Cover the toilet seat to ensure tightness. You want to use the pressure of gas to open the toilet seat.

5. after sealing for five to ten minutes, press the flush button to flush. On the one hand, it increases the pressure in the toilet, which is beneficial to dredge the toilet. On the other hand, flush the toilet to wash away the smell of baking soda and hydrochloric acid.

Third, never flush the toilet with hot water.

1. Some people think that you should never flush the toilet with hot water when dealing with the problem of toilet blockage. So what is the reason? In fact, in the process of flushing the toilet with hot water, the transpiration of water vapor will not only corrode the wall, but also make the smell outside the concrete around the toilet more intense. In addition, too much water will also lead to the smell of fog, which is not good in any way.

2. In addition, in case the waterproof construction of the bathroom is not done well, the probability of water seepage is very high. This waterproofing refers to the secondary waterproofing during decoration. The steam generated by hot water will cause cracks in walls and even concrete.

the toilet is blocked with shit. Trick 2

The toilet is blocked with shit.

1. soak for a while, and then add a large basin of hot water to the toilet. Increase the pressure and flush it down. It doesn't matter.

2. The simplest method is to mash the feces with a wooden stick after defecation. If not, prepare a basin of defecation water, add a basin of water, and increase the water pressure guarantee.

3. Use the toilet plug. If the water won't flush, use a toilet plug. Put the toilet in the toilet and press it several times. Remember, before you press it, you must absorb it, let the vacuum pressure suck up the blocked things, then press it again, and finally flush it with water until the water can flow smoothly, which proves that the toilet is unobstructed.

4. Pour a little toilet dredger and a few drops into the toilet. Pour a pot or half a bucket of waist-high hot tap water into the toilet bowl. The reason for pouring water from the waist height is that this height of water can help clear the blockage or corrode it.

knowledge of toilet maintenance

1. make sure that the water shut-off valve of the toilet is in the closed position.

2. after removing the plunger of the float valve, you will see one or two washers (or O-rings). If any of these parts breaks down, water will continuously flow out through the valve plunger, and the water tank of the toilet will always be open. Therefore, all gaskets should be inspected and replaced immediately if damaged.

3. if the float valve is sealed, replace it completely. Turn off the water source of the toilet at the water shut-off valve, and then drain the water in the water tank. Unscrew the floating arm from the old ball valve, and then remove the water injection pipe from the overflow pipe.

4. find the connecting nut or sliding nut under the water tank, where the water inlet pipe enters the bottom of the water tank. Loosen the connecting nut, remove the water inlet pipe, and then clamp the lock nut or lock nut under the water tank with adjustable wrench. They are located above the sliding nut and hold the base of the float valve with another wrench in the water tank.

5. unscrew the lock nut under the water tank and remove the float valve. If the nut is too tight, loosen it with permeable lubricating oil.

6. Take out the old device in the water tank, and remove and keep the gaskets at all joints inside and outside the water tank. There may be new gaskets in the new valve, but the old parts should be kept until the new device is installed to avoid the damage of the new parts during installation.

7. insert the new ball valve into the hole of the water tank. After the gasket is installed in the water tank, tighten the lock nut outside the water tank, so that the inner gasket is tightly pressed on the hole of the water tank, which plays a sealing role, but do not tighten it too tightly.

8. replace the connecting nut and water inlet pipe, reinstall the floating arm, and then insert the water injection pipe into the overflow pipe.

9. Let the water flow out again on the closed valve of the toilet, and check whether there is water seepage in all parts. Of course, check whether the floating ball scratches the back wall of the water tank. If there are these phenomena, make appropriate adjustments.

the toilet is blocked with shit. Trick 3

1. What should I do if the toilet is blocked? The simplest trick

has been used several times, and a kind of "pipe connection" sold in supermarkets is quite effective, around 1 yuan. Once every half month, it won't be blocked.

second, what should I do if the toilet is blocked? How to solve the frequent blockage?

try a longer one, not hard but not very soft. Insert a soft snorkel into it, and flush it with water at the same time. Don't push the water too hard, so as not to spill it, and then flush it. I tried it, and it worked well.

third, what should I do if the toilet is blocked? User's spoof trick

If it is blocked by easily decomposed objects such as confetti, you can pour boiling water to soften the blockage in the sewer pipe first, but don't worry too much. Soak for a while. After the blockage is softened and dispersed, watch the sewage drain away slowly, and then rinse it with big bucket of water.

You go to the fish market to buy some loach fish, live, and pour them into the toilet. Just a moment. This is an exclusive secret recipe. I won't say anything about ordinary people!

fourth, what should I do if the toilet is blocked? How should I clear it?

1. Clean the toilet with a rag.

you can find a hose, one end of which is connected with tap water, and the other end is wrapped with a rag and inserted into the sewer pipe. Just turn on the tap water. Principle: The tap water pressure is about 4Mpa, which can completely flush your sewer. Remember not to let air leak at both ends of the hose to maintain the highest pressure.

2. dredge with a drink bottle.

I bought a bottle of Coca-Cola, drank it, cut off the bottom of the bottle, put it upside down in the toilet, hold the bottom of the bottle with my hand and take a few sips up.

3, toilet spirit dredge

buy a bottle of toilet cleaning spirit in the supermarket. This is corrosive, so be careful. Introduce hot water into the squatting pan first, and then introduce liquid. The amount introduced needs to be read in the instruction. After the last half hour, use the toilet suction tool of method 1, the leather tiger.

4, professional experts to dredge.

If all the dredging methods described in the article have been tried, but the cause of the toilet blockage can't be found, you can call a professional master to dredge it at this time, so as to avoid more trouble if you don't know how to make the toilet more blocked.