The simplest way to make a Barbie doll is as follows:

Material preparation: one doll, a set of skirt supports, 2.5cm wide purple ribbon, 10cm long N strips, 7cm long 15 Strips, 4 strips 26cm long, one 1cm wide glitter strip 26cm long, 2.5cm wide pink gauze strip one meter long, needle, thread, scissors, tweezers, lighter, glue gun.

1. Take a 10cm long ribbon and lay it flat on the table with the inside facing up.

2. From the middle, fold the upper part to the right.

3. Then fold the right part down and overlap it with the lower part.

4. Starting from the left, fold the ribbon upward first, then fold it down. After folding, there will be two convex peaks in the middle, and the edges on both sides are facing upward.

5. Then cut off the excess part and burn it with a lighter. Use the same method to make a few more petals.

6. Take out the skirt support and start gluing the first layer of petals from bottom to top.

7. The sharp corners under the petals of the first layer are a little more than the bustle. Then one by one, glue them next to each other in a circle.

8. Start gluing the second circle, and the tip should cover the gap between the petals on one layer. Third level, same thing.

9. The top layer is like this.

10. Next, take out the doll and a 10cm long ribbon.

11. Use a glue gun to wrap the ribbon around the upper body of the doll.

12. Glue a petal on the chest and back of the doll.

13. Place the doll on the bustle and use a glue gun to apply glue around the waist to fix the doll.

14. Take out one meter of gauze tape with a width of 2.5cm, and use a needle to thread it from one side of the gauze tape until it is finished and tie it.

15. Glue the sewn gauze tape to the waist of the doll, making sure to leave a gap at the back waist.

16. Take a 26cm long purple and pink ribbon. A 1cm wide strip of glitter.

17. Fold the purple ribbon down from the middle, leaving an angle of 30 degrees between the two sides.

18. Fold the pink ribbon in the same way, then place it on top of the purple, and fix it in the middle with a glue gun.

19. Take a 26cm long purple and pink ribbon. Fold in half from the middle.

20. After folding the ribbon, fold the right side down and form a certain angle in the middle.

21. Fold the pink in the same way and place it on top of the purple.

22. Fold the upper end with a bow knot. After folding, wrap it with QQ thread several times.

23. Glue the ribbon made in step 18 to the gap on the doll’s back waist.

24. Glue the result in step 21 on top and cover it with gauze tape.

25. Fold the glitter strip in half and stick it to the inside of the middle.

26. Use the base of the bustle to cut out pieces of fabric of the same size.

27. Press the base.

28. Glue the non-woven fabric on top.

29. The doll is ready.