A, breeding methods

1, potting soil: breeding green pots have a lot of choices, you can use ceramic pots, clay pots or plastic pots; soil permeability and drainage should be strong, so as not to produce stagnant water inside the potting soil. Cultivation can be prepared with a mixture of leafy soil, garden soil, river sand and perlite.

2, moisture: green Luo suitable for growth in a moist environment, to keep the soil slightly moist state, there can not be excess water inside the pot. Can according to the situation in spring and fall 2-3 days watering once; summer watering every day or morning and evening watering once, but also at any time to the leaves spray to increase humidity; winter can be 3-5 days watering once, the water temperature is best and the room temperature is about the same, otherwise it will also be it frostbite.

3, light: usually breeding the best to let it receive diffused light irradiation, can not be strong direct sunlight, to be placed in a well-ventilated place maintenance. If the indoor breeding light is not good on the interval of 10 days or so in the sun, or long-term growth in the dark place easy to grow poorly. If you breed outdoors, do a good job of shading, especially in summer, do not receive direct light.

4, fertilization: fertilize the green usually use organic fertilizers, the growth season to more fertilizer, fertilizer is generally nitrogen, phosphorus and potassium fertilizer. Do not fertilize it in winter, usually fertilize to thin fertilizer, one-time fertilization is too large, there will be the case of burning roots.

Two, notes

1, just hydroponics when the water change to be diligent, 1-2 days to change the water, grow new roots after a week change is good.

2, we must often observe the hydroponic root growth, if there is a rotted root, we must clean up in time, and other roots are cleaned again, if necessary, with a diluted potassium permanganate solution to eliminate the poison.

3, green growing more dense if you want to prune properly.

Expanded information:

Green cuttings propagation method

1, spike selection and processing: spikes should be selected to grow healthy without pests and diseases of semi-woody branches, cut into 10-13 cm long, the lower incision cut into a diagonal, the upper end of the left 2-3 leaves, leaves cut off half, to reduce water evaporation, conducive to The spikes will survive.

2, cuttings substrate: cuttings substrate requires loose breathable, well-drained, humus-containing high loam or sandy soil, preferably with vermiculite, so that the rooting fast, high survival rate. Before insertion with 2% formalin or 5% potassium permanganate to do a good job of soil sterilization.

3, cuttings method: the lower end of the prepared spike dipped in ABT rooting powder or indole butyric acid, and then inserted into the pre-prepared substrate, into the soil 1/2, watering, so that the spike and the substrate in close contact with the spike, and then covered with plastic film.

4, post-insertion management

(1) After insertion, pay attention to keep the soil moist and higher air temperature. Soil humidity of about 50% is appropriate, while the air humidity of 80% -90% is the best.

(2) cuttings in the early stage of the shade degree of shade maintained at about 80%, which can prevent direct sunlight, but also to ensure that there is enough diffuse illumination, in order to facilitate photosynthesis with the leaves of the spike, conducive to rooting.

(3) through the above treatment, generally 20 days after the basic rooting, you can remove the film, increase the light, at the same time the summer sunny days still pay attention to leaf spray and shade, pay attention to the cold in winter, after the rooting of 10 days or so after the transfer of pots of normal management.

Reference: