The best way to adjust the fish drift is to find the bottom before adjusting the drift, adjust the aim, set the fishing aim and so on.

1, before adjusting the drift to find the bottom

Weighing the lead pendant to throw the main line with double hooks to the fishing point, and then move the float upward until it is flush with the surface of the water, which proves that the lead pendant has been to the bottom. This will give you an idea of the state of the bottom of the water. For example, the depth of the water, whether the bottom of the water is flat or not, and whether there is any debris.

2, adjust the eye

The float down to move about 20 to 30 centimeters to be greater than the distance of the drift length, and then cut off a little bit of lead, and then thrown to the fishing point, if you find that the float is completely submerged in the water, continue to cut the lead. Do not be in a hurry, must be cut little by little, until the float is exposed to the water surface, usually the first to four eyes, soft tail drift two eyes or 3 eyes can be, this is the adjustment.

3, set fishing

First of all, move the float upward about 20 centimeters, and then bait thrown to the fishing point, the pressure of the water line, do not be anxious, if the float sinks into the water, which means that the water line is not long enough, and then move the float upward, each time 10 centimeters or 5 centimeters or so.

Continue to hang the bait and cast until the float is again exposed to the surface to the original tuning, after that, you can continue to move up and down on this basis, the float a tiny distance, usually one eye or half an eye. According to the actual situation to determine the final fishing eyes, this is the fishing eyes.

The fish float is a tool that responds to the message that the fish are biting when fishing. Through the action of the drift, people can not only judge how the fish are eating, so as to decide the timing of lifting the rod, but also determine what kind of fish is biting through the action of the drift.

Fishing precautions:

1, the main line connected to the rod tip, be sure to use the space beans to lock, to prevent offline.

2, when moving the float, be sure to pull the rod back to prevent the rod tip from bending and breaking under stress.

3, move the space bean, be sure to wet the main line first, to prevent friction heat hair injury, easy to break the line.

4, the same hook, before pulling the line, the line pulled first wet, to prevent the line friction heat hair.

5. When tying the hook, be sure to rotate the wire to the inside of the hook shank, not only does not grind the wire, and pull the bait is smooth and full.

6, when the rod out, must be a little harder, the best rotation, so that the rod force is uniform, not easy to break the rod, and not easy to enter the water.

7, before closing the rod, be sure to use a towel to wipe the rod clean, to prevent corrosion of the rod, to extend the life of the rod.

8, fixed-point spinnerbait is better than awarding the need to change the position of the ground bait. After determining a fishing spot, you should insist on spreading more bait often, so that the fish often swim to the fixed point of the waters "dinner" for food, forming a habit.