The cigar is cut at a 90-degree angle to the scissors.

As the name suggests, cigar cutters are scissors used to cut cigars. The sharpness of the cigar cutter will have a direct impact on the cut of the cigar. Cutting a cigar with an inferior cigar cutter will damage the cigar, hence the importance of cigar cutters to cigar owners. Why can't ordinary scissors cut cigars? Professional cigar cutters are specially designed to cut cigars according to the shape of the cigar. Usually, cigar cutters with diamonds are relatively small with a pocket watch and a small keychain which are attractive and easy to carry. Boring cigar cutters are more suitable for beginners as these have a smaller opening for beginners who do not have as large an intake. There is also no chance of unsuccessful cuts that could damage the case of the cigar and fall apart.

The cigar is in parallel with the drilled cigar cutter, and the blade rotates strongly around the center of the cap.? Please note that the force should be moderate, if the force is too small it will not rotate, if the force is too large it will easily turn to the center, affecting the effectiveness of the cigar's suction pulling it to a certain depth, the cap will fall off by itself. However, since drilled cigar scissors usually make holes that will be smaller, you can use the center of the cap as the center to rotate it upward one and cross it one or two times if you need a larger suction.

This type of cigar cutter is better and won't cause the outer layer of the cigar to be damaged and fall apart, and when cutting out the V-cut, try gently cutting out the cigar with the tip of your tongue. Cutting the cigar will give you a different flavor when you smoke it. The V-shaped cigar cutter fits its name perfectly with a V-shaped cut. These cigar cutters are also cosmetically beautiful and easy to carry, but usually require a cigar size. Larger cigars may not fit. Hold up a cigar cutter with one finger four fingers below it. Orient the cutter and cigar at 90 degrees. Cut the cigar cap. Single-blade cigar cutters should not be used for larger cigars. Single-blade cigar cutters have a richer appearance. However, since the scissors need to be pulled from the bottom and cut downward, I think it is more likely that the blade will come loose and interfere with the cut. Hold the cigar cutter with one finger and four fingers to prevent it from wobbling from side to side. Then place the cigar cap under the cutter and make a large or small cut depending on the desired inhale.