Prepare materials and tools
Material: wood
3 boards of 2700* 120* 18.
At least 2 to 3 pieces of 2700* 1400* 18 cardboard (personally, three-ply board is better).
Three extra-long screws with spirals? -? Paint and varnish
Tools:? -? Vertical? -? Drilling machine
Diy bookcase making method
Step 1:
Fabrication of vertical panel frame
First, cut the shape of the board, vertical and horizontal lines.
Three vertical boards must be the same size. Shelves can be placed at will. Big or small, the big one can put two thick classical masterpieces and photo albums. These just need to be changed in length and width.
The trick is to cut a beautiful arc. The horizontal board is basically straight, but it is cut into a curved shape 40 cm from the end.
Step 2:
Cut and carve? The most complicated step in the whole process is to accurately saw out the notch where the cross frame and the vertical frame fit. Each transverse plate is cut with three notches, as shown in the figure, one in the core and two at 20 cm from both ends. The notch on the vertical plate is cut according to your own needs, because it directly determines the size of the grid space. Adjust the position of the incision according to the size of your book.
You can refer to my data: on the layer where the photo album is placed, the distance between the two notches is 33 cm, 30 cm and 26 cm in turn. ? Accurate measurement, marking, and then incision. If the measurement is not accurate enough, the bookshelf is not balanced enough.
All cuts should be 18 mm wide, so that boards can be inserted.
As for the depth of the incision, that is, the notch, that is the trick.
The vertical plate is curved, so it is impossible to cut all the notches to the same depth. I suggest that the incisions are all less than the average width 1/2. For example, the width is 12 cm, the incision is 6 cm, the width is 6 cm, and the incision is only 3 cm.
It is emphasized that all the notches on the vertical plate should be the same size and depth.
The notch on the horizontal plate should match the notch on the vertical plate.
Step 3: Install
Now you can assemble all the boards to see if they match well, and then take them apart and apply paint and varnish. Of course, if you have it in mind, you can paint it directly.
Step 4: Embedding in the wall
After finishing all the painting work, assemble the boards where you want to put the bookcase. You don't need to install the board except the one used as the top shelf.
Drill holes in the notches used to place the top frame, insert screws, pass through the board, and drill holes in the corresponding points on the wall for fixing. If you are worried that there is not enough wood at the notch, you can drill holes in the board above the notch. ? The whole bookshelf is formed, and these holes are not visible, which is absolutely beautiful. In this way, the screws can't be seen from the outside, and it feels as if the bookshelf exists independently.
Step 5: Finish? A bookshelf has been made successfully. Now you just need to put your books on it and enjoy the fun of small achievements.
Conclusion: The above is some related information about DIY bookcases that Xiaobian told you today. I believe you have a simple understanding of this information after reading Xiaobian's story, right? In fact, the rules and design of making simple bookshelves at home are not so complicated and the design is exquisite. As long as everyone likes it, they can do it according to their own ideas. The height, size and height are not a problem, as long as they loOK good, it's ok!