How to use the dumpling wrapper machine

1. Place the machine on a solid ground and connect to the 220V power supply. Install a leakage circuit breaker. And connect the ground wire.

2. Before starting the machine, check whether the bolts of each part are loose? Start the motor and run it idling for one minute? After making sure it is correct, put it into production?

3. Dough kneading: manual and dough kneading machine Both are available. (A little salt should be added to the water) Be careful not to make it too soft. The ratio of flour to water is 1:0.35-0.43.

4. Fill the flour hopper with dry flour before starting the machine, and add the flour and water. Put the good noodles into the noodle bucket. Put the noodles in without interruption.

5. Adjust the dough thickness after turning on the machine. After the dough piece is normal, adjust the mold roller to make the pressure moderate. Send the waste dough to the dough hopper from the conveyor belt. After the adjustment is completed, the nut should be locked.

6. When the machine head is lowered to the conveyor belt, the dough piece should enter the chess piece flatly. Otherwise, the side will stick to the mold.

7. When producing noodles, remove the noodle pressing tool. Just install it on the front of the machine. The tool must be installed all the way and locked tightly. Then catch the chain and you can start production. Just remove it when not in production.

8. The adjustment of the machine can be adjusted according to the subsequent adjustments. Dumpling wrapper machine

Precautions for dumpling wrapper machine:

1. There should be no gaps when feeding into the dough hopper to ensure that the machine works normally, otherwise the dough will be unqualified. .

2. The dry flour in the flour hopper must not be interrupted, otherwise the side skin will stick to each other.

3. Open the gearbox regularly and add lubricating oil. Chains and sprockets should be kept lubricated regularly.

4. After the machine is shut down, the machine should be cleaned and maintained to ensure the normal use of the machine.

5. It is strictly forbidden to put your hands into the machine head or mold to avoid accidents.

6. When installing the noodle cutting tool, it must be locked.

7. When disassembling and assembling the noodle pressing mold, the power supply must be unplugged to avoid accidents.