Superior electric pressure cooker e0 fault may be: the upper cover thermistor open or short circuit, the cover is not in place or agitation switch and its connecting wire failure.

Superior electric pressure cooker display e0 failure of the first reason is the cover thermistor open or short circuit (normal 100K/25 degrees Celsius), replace the cover thermistor can be. The second reason is that the cover is not in place or agitation switch and its connecting line failure, the solution is to close the cover normally, check whether the agitation switch and its connecting line is normal, whether the micro switch contacts can be effectively closed after the normal box cover.

When Nepal electric pressure cooker display code E1, the first reason may be no pot alarm, the solution is to check whether to drop the pot or inner pot with the wrong. The second reason is that the temperature sensing cup is faulty (thermistor open circuit or short circuit), the solution is to replace the temperature sensing cup assembly.

Superior electric pressure cooker other faults and their solutions

1, when the Superior electric pressure cooker display code E2

The first reason is the empty pot dry burning, the solution is to restart the pot with water. The second reason is the high temperature alarm, thermistor failure, the solution is to check the bottom of the pot whether there is oil, foreign objects, replace the thermistor. Thermistor failure, temperature sensor failure, the temperature sensor in the center of the heating pan has poor contact or broken circuit. Replacement of the chassis sensor, detection of sensor voltage, voltage is not normal in the detection of words check the CPU detection foot voltage, capacitance resistance to ground and other original components.

2, when Nepal electric pressure cooker display code E3

The first reason is the beginning of the detection of the upper pressure (at this time should not be on the pressure), the solution is to replace the inner pot cover or stop open valve. The second reason is that it should be pressurized but is not (by detecting the temperature), the solution is to replace the reed switch or connect other connecting wires. The third reason is that the stop-open lever cover falls down but does not, the solution is to check if the stop-open lever is down.