1, to the water tank to add clean tap water, the water level should be in the prescribed water scale line.
2, in order to ensure the safety of the operator, to check the bean sprout machine has a reliable grounding measures and devices.
3, plug in the power supply, adjust the electrical appliances merge the various actions on the dashboard knob, require the corresponding indicator to be sensitive.
4, check the manual water spray system can spray water normally.
5, with a thermometer to proofread the automatic temperature control system of heating and thermostat device technical performance is normal, reliable, temperature indicator value is accurate.
6, check whether the technical performance of each part is good, whether the connection is firm, and whether there is no leakage in each part.
Two, boot production bean sprouts should be done daily management
1, close the door. During the production of bean sprouts, try not to open the box door to reduce the contact between bean sprouts and air.
2, adjust each knob. In accordance with the technical requirements of the bean sprout machine manual, the temperature control knob, water spray interval control knob and water spray continuation time control knob adjusted to the specified range.
3, pay attention to observe the instrument panel on the various indicators to see whether they are in their respective provisions of the operation of the normal work.
4, observe the water supply and drainage conditions. Each time the water supply, observe the drain outlet water with or without abnormalities, found that there are abnormalities, should open the door of the box to check, troubleshooting in a timely manner. During the troubleshooting period, pay attention to the machine on time to the growing bean sprouts for artificial water.
Three, the growth of bean sprouts should be done after the completion of the work
1, cut off the power switch, and then open the box door, remove the box of bean sprouts, and will be germinating box clean, while dredging the bottom of the box small mouth drainage holes.
2, rinse the inner wall of the body, clean the filter.
3, check the technical condition of each part, such as leakage phenomenon, can be coated with epoxy resin to be sealed; such as found loose connection, should be tightened in time.
4, the electrical components in accordance with the requirements of the manual for regular inspection and maintenance.