The method of folding toilet paper for roses is as follows:

1. First, fold the square paper in half vertically and horizontally. At this time, fold the left bottom corner of the square in the lower left corner diagonally. When completed, it will look as shown in the picture. Fold the remaining four corners in the same way. When finished, flip the paper model over. Do the same thing on the other side. Fold the right bottom corner diagonally to the left along the crease. Flip paper model. Fold the origami model in half. After all folds are completed, unfold and rotate the origami model 90°, and then fold it again according to the previous steps.

2. Fold points A and B toward the positions marked below, and fold a partial crease in the middle. When completed, it should look like the picture below. Make a horizontal crease at one point where the crease passes. After folding is completed, restore the fold and rotate it 90° before performing the same folding operation as before. Take the middle crease. Take the midpoint and fold it up. After opening the origami model, fold the lower left corner backward. Fold the bottom edge toward the midpoint. After folding is complete, unfold the origami model.

3. At this time, make a mountain fold on the crease, that is, fold it to create a partial peak mark. After folding both layers, open the origami model. Take a midline between the two creases and fold it into a valley mark. Open the origami model when finished. At this time, turn the structure on the right side of the crease to the left and back. Take two rectangular diagonals, with peak marks and mountain folds. The steps are too complicated, you can also go to the web link to check it out.