The plastic mixer adopts the working principle of spiral mixing. The material is sent to the upper end of the barrel through the spiral main shaft, and then falls in an umbrella shape, and the mixing action is continuously circulated, so as to achieve the effect of uniform mixing of the material. Adopt This mixing method can fully mix various materials evenly, improve production efficiency, and there will be no waste of materials. The plastic mixer has functions such as automatic operation timing, overload protection, and feeding limit alarms. These functions allow The mixing procedure is more complete, and it also has the advantages of less floor space, large capacity, low power consumption, labor saving, convenient control, fast and even mixing, etc. It is widely used in some productions that require mixing of materials, mainly plastic flakes, crushed materials, plastic particles, new and old plastic materials, and adding color masterbatch and stirring evenly. Generally, machinery brings a lot of convenience to production, but the maintenance of machinery It is very important. If you do not perform regular maintenance, the machine will rust and fail to operate normally; at worst, it will seriously damage the machine and shorten its service life. Generally, the maintenance of plastic mixers includes: Daily maintenance content: after use every day Clean the mixer: Use a wet towel with water to clean the mixing hook, dividing rack and mixing tank. Do not leave any water in the tank. Weekly maintenance content: The entire mixer needs to be cleaned every week, and be careful not to flush the equipment with water. Monthly maintenance content: 1. Use a grease gun to grease all the grease holes in the bearing seat once a month or quarter. 2. Add lubricating oil to the chain and gear parts. 3. Check the tightness of the belt or chain to prevent damage to the belt or chain caused by slipping.