1, according to the size of the required ball, cut a piece of cardboard first, or wrap the thread around the fingers after the four fingers or three fingers of the left hand are together.

2. The diameter of the four-fingered ball is about 6-7 cm. The more coils are wound, the denser and tighter the ball is. The diameter of the three-fingered ball is about 5-6 cm. The more coils are wound, the denser and tighter the ball is.

3. Remove the wound coil; Find a wire with good fastness about 10cm long, tie it tightly in the middle of the coil, and then tie the wire in a knot; Leave a 5cm thread at both ends of the knot (used to hang the ball on the scarf).

4. Cut both ends of the coil with scissors. Shake it and spread it naturally. This is a ball! Then use scissors to cut off the long lines along the edge of the ball until all the lines are uniform, and the ball is ready.

5. Finally, thread the 5cm thread left when tying the ball into the ball hanging place of the hat, and then tie two knots at the second thread to hang the ball. Then the center of the circular paper is hollowed out, with a diameter of about 3 cm.

6. Then put two pieces of cardboard together and wrap them on the cardboard for ten cents. (It takes about 2 meters of thread 10 to make a thick ball. If it is thin, it can be done in proportion. )。

Hats are clothes worn on the head, most of which can cover the whole head. Mainly used to protect the head, some hats will have protruding edges, which can block the sun. Hats can also be used to dress up, protect hair styles and cover baldness.