First, prepare the materials and tools we need to weave bracelets, including five red lines and several beads. The best choice for wiring is red beads.

Then you need to prepare scissors and lighters. The thread diameter I chose is 0.08 mm. When it is ready, let's start knitting. First, arrange four red ropes of equal length in a row and tie them in a knot. Be careful not to tie it too tightly.

Then put the red rope flat on the table. Next, arbitrarily choose the outermost red line as the axis. The axis does not move, and then the other three red lines are woven into oblique knots with the axis. Oblique knots are bracelets, especially wide bracelets, which are very common knots. After completing the second step, take the line in the direction of the right arrow as the axis, and the axis will not move. Then, weave the other three red lines with the axis as the diagonal knot, which is the diagonal knot. Then use the beads to cross the second line on the right.

Prepare three colored ropes, as shown in the figure. I use pink and brown. A brown one and a pink one are more than twice as long as the other pink one.

Tie a knot at 6 or 7 cm of the rope.

Operate the long pink rope and brown rope.

Repeat step 3, but alternate left and right sides.

After weaving to a certain length, thread the pearl into the middle shaft rope and continue with step 3.

Continue to repeat the above steps and stop the above steps according to the circumference of the wrist.

Cut a rope about 10 cm.

Tie the newly added rope to the middle shaft rope and weave according to step 3.

Burn a circle with a lighter, and when it becomes liquid, quickly pinch it with your hands.

Put pearls at the end of each rope.