Handmade dragon boat making methods and pictures are as follows:

1, the length and width ratio of 3:1 or 4:1 rectangular paper folded horizontally, spread out to get a central fold line.

2. Fold corner A, side A to side B in the picture above, that is, fold corner B in half, spread out to get a diagonal fold line.

3, corner B, side B repeat the action of 2.?

4, with the index fingers of both hands, the A side, the B side in the action steps 2, 3 made within the folding line of a section of the inward pressure, with the help of the middle finger and thumb will be the corner of the A, B according to the folding line of the folding line, and will be on the top of the triangle flattening, this part of the dragon boat to be the bow of the boat.

5. Fold the entire sheet of paper in step 1 to make the fold line, which is the center line of the bow triangle. Will be marked in the figure of point C downward fold, the left side of the diagonal edge and the center line C line alignment. Open it up and fold corner C upwards, aligning the bottom edge with line C, and spreading it out to make a cross-folding line D and E.

6. Use your right index finger to press down on the right triangle of the D and E lines. Left thumb and forefinger along the d, e line will be corner C folded, stand up, the sequence of actions shown in the figure below, after the completion of the corner C can be folded or stand up before and after.

7. Repeat steps 5 and 6 for corner D.

8. Fold G to H in Figure 21 above, and then fold and align corner E to the center line. Flip corner G back into place.

9. Repeat step 8 to fold corner F.

10. Fold the top rhombus back using the center fold line of corners G and H as the base.?

11. Using the hexagonal side as a baseline, fold the entire triangle portion on corner i's side toward the b side.

12. Repeat step 12 on the right side and finish with two fold lines, which are used to prepare the bow of the boat for lifting.

13: Fold both sides of the piece to the back according to the center line from step 1.

14: Fold the nail side toward the center line and align it with the corner K. Fold the corner K toward the center line and align it with the center line.

15: Repeat step 14 for the other side, and fold the hull to the center line.

16. Make the stern: Fold the end of the hull down until it lines up with the folded edge of the triangle at the end of the boat, resulting in the Sin and Jen lines shown in the photo below.

17.? Using the folded lines Sin and Ren, fold and stand each side of the stern upwards.

18: Fold the tip of the bow down about one centimeter and up about half a centimeter to create the mouth of the dragon boat.

19. Fold the two triangles at the other end of the boat's bow to the front, then fold the triangles back about one centimeter from the fold line. In order to make the dragon look more energetic, you can adjust the two corners of the dragon's head a little upward.

20. Place the boat on its side with a cutting mat or thick paper underneath, and use a craft knife to make small lines on both sides of the boat. Take the thicker paper cut out two paddles, respectively, from the outside of the hull into the paddle, Dragon Boat Dragon Boat is complete.

The above is how to make a dragon boat.