Through the pipe icing response methods are introduced as follows

Method 1: hot water irrigation iron

Prepare a pot of hot water, evenly poured back and forth on the water pipe, if the freeze is more serious, you can pour a few times to try. Do not use boiling water to scald the water pipe, so as to avoid the phenomenon of water pipe burst. To thaw a frozen pipe start with the pipe at the faucet and gradually move to the other end of the frozen area. Water and steam will come out of the open faucet as you melt the freeze.

Method 2: High Temperature Equipment Cooling

The temperature of the flame coming out of the blowtorch is very high, up to 800 to 1,000 degrees Celsius, so it is the fastest way to deal with the problem of freezing water systems compared to other methods of thawing. However, the disadvantage of using a blowtorch to defrost is that there is no guarantee that the water system will be completely smooth when the pipes are severely frozen.

Expanded Information:

Introduction of pipe anti-freezing measures

1, good pipe insulation. Air source heat pump heating pipe insulation outdoor B1 level 30mm thick, indoor can use B1 level 20mm thick. Outdoor thermal insulation outer layer using aluminum skin, indoor thermal insulation outer layer using white tape tie. Pipe valves and bends must be well insulated, and there can be no exposed points of the pipe.

2, plus antifreeze plus antifreeze. In areas with low winter temperatures, it is recommended to add -15 ℃, -25 ℃ antifreeze in the pipeline to prevent freezing caused by low temperatures and temporary power outages.

3, on the water pipe heat transfer, used in solar water heaters more, but used in the pipe insulation heating is also feasible, but the price is a little expensive. Of course, with a hot towel, with hot water dripping pipeline is also possible.