strawberry origami

1, take a red square paper.

2. Fold a zigzag crease (preferably the horizontal line and vertical line are folded in the right direction and the diagonal line is folded in the opposite direction), and press the two sides of a horizontal line toward the middle, as shown in the figure below, to fold a smaller square.

3, according to the following steps to fold. (The photo shows that the upward corner is the center of the original square paper)

4, as shown below, fold the crease, then open it, flatten it, align it, and the two sides are consistent.

5. Fold up the lower triangle, as shown in the figure below.

6. Turn the paper over and repeat the steps in the third, fourth and fifth pictures above.

7. Fold the folded two faces to reveal the other two faces that have not been folded, and fold one face as shown in the figure below.

8, fold the other side in the same way.

9. Put your finger in it, hold it up, adjust the shape, and then fold back the four small triangles, as shown in the figure below.

1. When the strawberry is partially folded, continue to fold the green leaves, and take paper that is just a quarter of the size of red paper, and green square paper. Fold the rice crease.

11. Fold out a small square just like the strawberry part at the beginning, and then continue to fold in half.

12. Draw the shape of a small leaf and cut it along the line.

13, cut off the lower end of the small leaf, and then cut off a little sharp, just a little bit. After unfolding, gently pinch your nails on your fingers and pull out the curvature of the leaf.

14. Fold out the twigs on the leaves as shown below. If it is too long, cut a part and adjust it randomly. Then insert it into the small hole in the middle of the leaf.

15. Use glue, tape and the like to give full play to your intelligence and stick the leaves and strawberries together.

16, draw some small black dots with black strokes, and it's done.