1. First, this machine puts the big apron on the container as it is. The sealing ring must be kept horizontal, and then aligned vertically downward with the evaporator. Pay attention to flatten the pump body vertically downward, and it is not allowed to tilt back and forth. Must be cleaned and disinfected before use, specific steps:

1) Take out the heavy madness gently.

2) Hold the spray water pump by hand, gently pull it up, and pull it out (spray) after rotating the spray pipe. Take out (stir) the stirring blade from the stirring support sleeve by hand. Note: Don't forget to install the sealing ring.

3) After the above components are removed, slowly swing your hands upward to lift the container. If there is any difficulty, it is necessary to wet the stainless steel evaporator and gasket. After cleaning the removed parts, reinstall and operate in the opposite way. Note: Please do not use hot water above 80 degrees Celsius to clean the plastic and rubber parts of this machine, so as not to damage the parts.

2. Start-up work: When all components are installed, drinks must be filled. When using the heating function, the beverage must be filled with more than 6 liters. It is best to adjust the thermostat to 50-65 degrees Celsius, and it is forbidden to heat without drinking drinks, otherwise it will damage the refrigeration and heating parts. Dear users, according to the different types of machines you choose, please start the machine in the following way.

(1) Press the fountain/mixing switch up first, and then press the refrigeration switch up, and the machine will enter the refrigeration state, with the temperature below 5 degrees Celsius and close to 0 degrees Celsius.

(2) If heating is needed, first press the fountain/mixing switch upward to adjust the temperature to the temperature you need. If one of the cylinders does not need to be heated, the thermostat of this cylinder should be set to the stop position, and the temperature you need can be adjusted for each cylinder according to the situation.