Uses and characteristics
The cold drink machine can make all kinds of cold and hot drinks such as cold and hot milk and fruit juice, which is convenient to use, clean and hygienic, and is an ideal equipment which is very popular in the catering industry. The cold drink machine adopts stainless steel evaporator, which has good heat transfer effect and fast heating and cooling speed. The cold drink machine has the advantages of small size, light weight, low power consumption and convenient operation.
method of application
1, before use, tighten the cutting knife and centrifugal filter, then fasten the upper box with centrifugal filter and cutting knife on the base, and then turn on the power supply;
2. Don't put food until the motor rotates normally;
3, the amount of food should not be too large, too thick, too hard, so as not to damage the cutting knife and cause motor overload;
4. Too much broken food should not be stored in the centrifugal filter, and it should be cleaned in time, otherwise it will easily cause vibration; Always keep the juicer clean inside and outside. Wash carefully after each use. But when cleaning, you must not use the faucet to wash the base of the lower part of the juicer, and don't put the body in water to avoid the insulation of the electrical part being destroyed.
Cleaning and operating instructions
1, the machine first puts the large apron on the container according to the original shape, and the sealing ring must be flat, then aim at the evaporator vertically downward, and pay attention to flatten the pump body vertically downward, and do not tilt back and forth. Must be cleaned and disinfected before use, the specific steps:
1) Take out the heavy madness gently upward.
2) Hold the spray water pump by hand, gently pull it out upwards, rotate the spray pipe and then pull it out (spray). Take the mixing blade out of the mixing support sleeve by hand (stir). Note: Don't forget to install the sealing ring.
3) After the above components are dismantled, slowly swing your hands upward to lift the container. If you have difficulty, it is necessary to wet the stainless steel evaporator and gasket. After cleaning the removed parts, reinstall them and operate them in the opposite way. Note: Please do not use hot water above 80 degrees Celsius when cleaning the plastic and rubber parts of this machine to avoid damaging the parts.
2. Start-up work: When all the components are installed, the beverage must be filled. When using the heating function, the beverage must be filled with more than 6 liters. It is best to adjust the temperature regulator to 50-65 degrees Celsius, and it is forbidden to heat without drinks, otherwise the refrigeration and heating parts will be damaged. Dear users, according to the different types of machinery you choose, please start the machine in the following ways.
1) Press the fountain/mixing switch up first, and then press the refrigeration switch up, and the machine will enter the refrigeration state, with the temperature below 5 degrees Celsius, close to 0 degrees Celsius.
2) If heating is needed, first press the fountain/mixing switch upwards to adjust the temperature to the temperature you need. If one of the cylinders is not needed for heating, the temperature controller of the cylinder should be set to the stop position, and the temperature you need can be adjusted separately for each cylinder according to the situation.