Pay attention to the diameter of the outlet when paying the bill for the faucet of the basin. At present, most of the water in the market belongs to the hard pipe inlet, so you should pay attention to the height of the upper inlet, and it is most suitable to go down from the basin to 35 minutes. When installing, you must choose a special angle valve, which must be fixed with the hot and cold water pipes out of the wall. When you find that there is a distance between the angle valve and the faucet pipe, buy a special extension pipe to connect it. Remember, don't connect with other water pipes, because if the water pressure is high, it will easily fall off and leak, causing you losses. If the inlet pipe is too long to exceed the outlet pipe, you can cut it off according to your needs. If the angle is not suitable, you can bend it to the position you need. Remember: don't bend to 90 degrees or more. When installing the basin for drainage, please don't forget to buy a small tap (tap short connection). Please don't forget to flush the water pipes buried in the wall before installing them.

Second, the shower, bathtub faucet (wall) installation:

When buying a shower, bathtub and wall-hung faucet, you can choose a suitable height to bury the outlet pipe. The distance between hot and cold water pipes must reach 15cm. Don't forget to flush the water pipe before installation to avoid damaging the faucet because of the excellent water quality.

Hidden shower and bathtub faucet: After purchasing the hidden faucet, the valve core of the faucet should be embedded in the wall. Pay attention to the thickness of bathroom wall before embedding. If the wall is too thin, the valve core cannot be embedded. Do not take off the plastic protective sleeve of the valve core easily when burying, so as to avoid damaging the valve core by cement and other sundries when burying. In addition, when you bury the valve core, you should also pay attention to the up, down, left and right directions of the valve core to avoid burying the valve core wrong. When the wall-mounted faucet is embedded in the water inlet pipe, the size is deviated, and the position can be corrected with an adjustable crutch.

Third, install a thermostatic faucet.

Before installing the thermostatic faucet, please check whether the water pipe is hot on the left and cold on the right, and remember not to connect the hot and cold water pipes by mistake to avoid the faucet from working normally. Gas and solar water heaters cannot use constant temperature faucets because the water pressure is too low. Please don't forget to install the hot and cold water filter when installing the thermostatic faucet.

Four, the installation of single hole kitchen faucet

Stability is required, because the kitchen faucet is used frequently and it is easy to loosen when moving back and forth, so the lock nut must be tightened. At present, there are some faucets on the market that use nuts to fix threaded pipes, and the stability effect is very good. If the problems of dehydration and lifting can be solved, it will be a popular trend in the future.

Prepare the installation tools and check whether the supporting parts are complete before installation. Common faucet parts are: hose, rubber washer, shower head, drain pipe, crutch, decorative cap, etc.

Many words, but more practical, I hope I can help you!