It is said that it is difficult to decorate the kitchen. We should not only consider water and electricity docking, but also reasonably embed electrical appliances. The design of moving lines and the storage of cabinets should not be sloppy. In this issue, follow Brother Pin to lay out the kitchen water, electricity and storage, and easily create your own personal tailor kitchen.

Kitchen-Gas

No matter whether it is an open kitchen or a closed kitchen, most families now choose pipeline gas, and two points should be paid attention to when designing:

Schematic diagram of kitchen gas layout

① Gas inlet pipes should be located in non-residential rooms such as kitchens, corridors or balconies connected with kitchens, which are convenient for maintenance.

② The smoke exhaust hole of the water heater should not be used with the flue. Try to set it near the basin or window for exhaust.

water level of kitchen sink

The hot and cold water inlets of the sink are generally arranged in the middle of the star basin cabinet (that is, the vegetable basin), with a height of about 511-611mm from the ground, and the water outlet should be located in the center of the star basin cabinet.

after installation, pay attention to check whether the connection between the water inlet pipe, sewer pipe and sink is firm, or your kitchen will be flooded. (ps: drainage test can not be less)

kitchen cabinet potential-range hood

range hood can be said to be a must in every kitchen, and the power socket is best installed above the range hood and about 21cm below the flat top.

and avoid the air outlet of the range hood. If not, you can mend the appearance of the socket covered with oil. (Brother Pin shivers inexplicably)

In addition, the tower-type range hood should also pay attention to the position of the socket above the electrical control box and inside the decorative cover, so as not to interfere with the air outlet pipe or the electrical box, and to ensure the appearance.

kitchen cabinet potential-disinfection cabinet

if you plan to build an embedded disinfection cabinet at home, the potential is usually located on the back wall of the appliance or the back wall of the adjacent cabinet.

kitchen cabinet potential-oven

A cook's kitchen needs an oven or a steamer. This kind of appliance is deep, and the socket is usually arranged next to the cabinet where the oven is located.

Many people are puzzled whether to install the socket on the back of the oven. Brother Pin's suggestion is not to do so as much as possible, because the high temperature generated during the operation of the oven can easily cause the socket to age due to long-term heating. (Of course, you can also avoid the heating problem by thickening the depth of the cabinet.)

Kitchen wall potential-socket

In the kitchen of people who like to cook, there are more than one kind of kitchen appliances, such as kettle, rice cooker and noodle machine, so it is necessary to reserve potential on the wall.

For the overall beauty, the microwave oven socket can be installed at the back of the microwave oven. However, since the microwave oven is a high-voltage product, attention must be paid to insulation, and it is best to choose a socket with switch control.

Kitchen-Other potentials

In addition to the above-mentioned common appliances, we may also use: dishwashers, water purifiers, small kitchen treasures, electric baking pans and other appliances, so we should also have a standby potential just in case.

water purifier

dishwasher

2-3 potentials are reserved in the sink cabinet, which can be used for kitchen appliances such as water purifier, kitchen treasure or food residue processor and dishwasher.

refrigerator

when the kitchen area is sufficient, the refrigerator will be placed in the kitchen. If the socket is inserted, it is generally 1311mm high and 511mm low, depending on the size and placement of the refrigerator. (Because the socket may be blocked by the cupboard)

Kitchen socket map

Kitchen moving line

What is a moving line? Simply put, follow the assembly line design of taking, washing, cutting, burning and serving, and the design of moving lines will affect the cooking experience. Corresponding kitchen appliances should be placed in different areas with sufficient spacing to ensure reasonable use.

kitchen storage

storage is also an important factor that affects our cooking efficiency. We always can't find what we want, which is the most annoying thing when cooking.

In fact, as long as you use a little "careful machine" in the cabinet design, your kitchen is absolutely enviable.

Kitchen appliances are embedded

Some common appliances, such as range hoods, disinfection cupboards, microwave ovens, etc., can be embedded in cabinets, making the whole kitchen regular and convenient to use.

store the basket

for the height of a domestic housewife, it can be described as "difficult" to carry the contents of the closet. Actually, this problem can be easily solved by designing a hanging cabinet basket ~

spatula, spoon, tableware seasoning and so on. You can get it as soon as you pull it out when you cook, which is clear at a glance and saves trouble. You don't have to be upset because you can't find anything anymore ~

L-shaped cabinets, but most of the corner positions are vacant, and there is nothing else. Because it is too much trouble to take things out, it is recommended to make a corner basket.

Other storage experts

Small hanging cabinets with glass doors have the feeling of "still hiding half her face from us behind her guitar", elegant and full of personality.

There is not enough space, so the wall can make up for it. Design some small pendants on the wall, where common objects are stored, and you can get them at your fingertips when you want to use them.

remember to like the collection, and you can leave your thoughts in the comment area, and Brother Pin will answer your questions at any time.