Department: Director's Office
Time: 20 10. 12.03
Fault: the computer can't enter the windows system, prompting that the system file is lost. The information is as follows:
WINDOWS cannot start \ Windows \ System32 \ Config \ System because the following files are damaged or missing. You can use the original startup disk or CD to start the Windows installer to repair the file, and select "r" at the top of the folder to start the repair.
Solution: Reload, drive C has no important data and can be overwritten, and the data is in drive E, which will not affect the data of drive E when reloading, and can be carried out.
Problem: (1), the reloading prompt failed, and the information is as follows: Microsoft Ram Drive version 3.0t virtual disk E:
Disk size: 4.096k
Sector size: 5 12 bytes
Allocation unit: 4 sectors
Directory entry: 64
No sectors found when reading drive A.
Abort, retry, ignore, fail?
Microsoft RAMDrive version 3.0t virtual disk Evan:
4.096k disk size:
5 12 bytes: the size of the sector.
Cation feeding unit: 4 departments
Directory entry: 64
The department did not find reading open.
Stop, try again, ignore, fail? )
(2) After (), PE starts again and cannot be loaded. The error message is as follows: Windows cannot start due to an error when starting from ramdisk.
Windows cannot open the memory disk image.
File Minipe\WINPE. Unable to load
The error code is 7.
Setup cannot continue. Press any key to exit.
Windows continues to run because there is no startup error when starting from RAMDisk.
Memory mirroring is not open in the window.
File Minipe \ WINPE. IS_cound is not loaded.
The error code is 7.
Installation cannot continue, please press any key to exit. )
(3) When the CD is started, it can only be accessed from the CD once after about five times, and there is no problem with the BIOS settings. Later, it was found that the CD was damaged and the CD-ROM drive could not be read. You can enter normally by changing another one.
Final solution: the solution is still the original solution. After changing a CD, I entered PE and successfully reinstalled Ghost XP under the PE system.
Summary: PE can be used to copy the important data in drive C before reloading. When finished, do not exit the system CD for reinstallation. It is best to reinstall in PE system. This has advantages. Sometimes, if the computer's hard disk is damaged, reloading with ordinary CD may fail, while in PE reinstall the system, most damaged tunnels (in the hard disk) can be skipped. Of course, it is possible to fail, but the probability is much smaller. If it still fails, it fails. It has to be tossed anyway. . .