Current location - Recipe Complete Network - Complete cookbook - Manufacturing dimensions of kitchen cabinets.
Manufacturing dimensions of kitchen cabinets.
1, the height of the kitchen console, the best cabinet height is 80-90cm.

Choose different counter heights for children's shoes with different heights. Please refer to the following data:

Height 150cm, height of kitchen console 80cm;;

Height 155cm, and the height of the kitchen console is 82.5cm;;

Height 160cm, height of kitchen console is 85cm.

Height 165cm, height of kitchen console 87.5cm:

Height 170cm, height of kitchen console 90cm;;

Height 180cm, and the height of the kitchen console is 95cm.

2. It is suggested that the depth of the basement is about 55cm, and the height is below the height of the console.

3. The height of the hanging cabinet is suggested to be about 60cm, and the local hanging cabinet can be considered to be 50cm.

4, the size of the sink area, the general length of a single sink is 60cm, and the general length of a double sink is 70-90cm. The depth of the sink is at least greater than18cm. The best height between the faucet outlet and the table top is 23-30cm, which reduces the problem of splashing water.

5. Table size division: drainage area >; 30cm, food preparation area > 60cm, loading area > 30cm.

6. Refrigerator capacity selection: 200L+ capacity for a family of three and 300L+ capacity for a family of five.

7. Installation height of range hood: 65-70 cm for top range hood; Side smoking machine 30-35cm.

Extended data:

Precautions for cabinet layout:

1. Keep the cooker at a certain distance from the wall, and try not to stick it on the side wall to avoid the collision between the pot edge and the wall.

2. On the side of the cabinet against the wall, the protrusion of the door line must be considered to avoid the switch of the door, drawer and basket being affected.

3. There should be enough space between the sink and the cooker, preferably above 800, but not too far away, so that it can run back and forth.

4, pay attention to the reasonable configuration of accessories, although the accessories of the cabinet are various, but the accessories suitable for each kitchen are different, which can be convenient to use and functional.

5. The joint of the table corner must have a reasonable area range, so as not to be broken under the influence of the acting force.

6. Pay attention to the reserved position of the socket. The socket between the countertop and the hanging cabinet should be far away from the sink. The socket of the refrigerator is best set on the side or upper side of the main wall, and so is the kitchen treasure. Microwave oven. Disinfection cabinet for range hood. Oven. Wait a minute.

7. The rectification of the gas pipeline needs to be coordinated with the gas company. It is best to make the gas outlet pipe and the main gas inlet pipe side by side, so as to minimize the area of the guarantee plate of the pipe on the countertop, so as to expand the use area of the countertop. The gas pipeline is rectified in advance to facilitate the opening of the cabinet.

8. There are two ways to solve the hood pipeline: first, before laying the brick ceiling, it is best to preset the hood pipeline in the ceiling and seal the side opening, and calculate the position where the hood outlet hangs out; Second, the settlement is in the lower part of the ceiling, and the hanging cabinet is covered with the ceiling plate after installation.