Many people actually don't know the disassembly method of the broken wall cooking machine, so I'll sort out the specific disassembly method here, please keep it. Dismantling method of the heatable wall-broken cooking machine: Dismantle the main machine 1, remove the base ① Remove the soft rubber head with long-nosed pliers, remove the fixing screw of the joint with a Phillips screwdriver, and remove the lower joint; ② Remove the damping pad by hand, and remove the four screws fixing the motor with a Phillips screwdriver; ③ Remove the four foot pads by hand, remove the four screws for fixing the base with a Y-type screwdriver, gently tap the sides of the main unit, and remove the base assembly (if it is necessary to remove the base cover, please use a Phillips screwdriver to cancel the .5 screw of the base cover) 2. Remove the power board, control board and motor ① Cut off the wire caps with scissors (just cut off the two wire caps on the motor connecting wire); ② Take out the motor, loosen the anchor screw with a Phillips screwdriver and remove the motor; ③ Remove the lower cover of the circuit board with a cross screwdriver, and remove the grounding plug terminal on the power board and the cable connected to the control board by hand, thus removing the power board; ④ Remove the key holder with a right-angle Phillips screwdriver or a small Phillips screwdriver, so that the knob switch assembly can be removed (please pay special attention to the steel ball and switch spring on the main body); 3. Remove the control panel, panel, coupler, power cord, main body, etc. ① Unscrew the screw fixing the control panel with a Phillips screwdriver and take down the control panel; ② Loosen the fixing screw of the coupling with a Phillips screwdriver and remove the coupling; ③ Remove the screws fixing the microswitch bracket and microswitch connecting rod with a cross screwdriver, and then remove the power cord, microswitch and other accessories; ④ Unscrew the screw between the main body and the motor bracket with a Phillips screwdriver, and remove the main body, panel and motor bracket. Dismantle the hot cup ① Separate the handle brackets I and II by a gap with a crew cut screwdriver, then pry the handle brackets I and II open with a disposable screwdriver and remove them from the glass (there is glue between the handle bracket and the glass handle, so please pay attention when removing); ② The microswitch and sensor can be removed by removing the screws that fix the switch bracket; ③ Remove the five screws on the heat insulation sleeve with a cross screwdriver, and take off the heat insulation sleeve; (4) Remove the connecting wire connecting the plug terminal and the temperature sensor, remove the two screws fixing the upper coupler with a cross screwdriver, and remove the upper coupler; ⑤ Fix the cup on the disassembly tool, rotate the cup counterclockwise, and remove the glass mixing cup, mixing tool holder assembly, tool holder sealing ring and other accessories. When removing the cold cup, use a hexagon wrench or pliers to rotate the stirring tool holder counterclockwise, so as to remove the tool holder assembly, the upper and lower parts of the tool holder sealing ring and other related accessories;