First of all, do a good job in basic materials. Pour a proper amount of glue (white glue) into the vessel and add a little water to increase the elasticity; Or take a group of ultra-light clay and add a little less water than clay to melt it (adding hot water will melt faster). If you choose to add water to clay, be sure to stir it evenly until it is paste.

Second, add foaming materials. This step is the simplest of the three steps. Add about one mineral bottle cap of detergent, laundry detergent, shampoo, shower gel and other foaming materials. If glue is used as the basic material, in order to get a transparent finished product, it is necessary to add a fully transparent foaming material; If white glue or clay is used as the basic material, transparent or opaque foaming materials can be added at will. Stir well after adding. If you want to add colors or decorations such as sequins, sequins and pearl powder, you can add them now.

Third, molding. This step is the most technical. If there is glycerol, glycerol can be added first to increase its stretchability. Next is the most critical step, adding a small amount of molding water several times. Molding water is mixed with baking soda water according to the ratio of 1: 30, or it can be changed into laundry detergent or contact lens care solution, and it is continuously stirred until it is molded. Until the styrofoam doesn't stick to the edge of the vessel, then continue to stir until it doesn't stick to your hands, and it's basically done!