Most bookbinding machines have a ruler to adjust the left and right positions based on this, and there is a single board behind to adjust the front and rear margins. Generally, the adjustable margin is about 2.5CM. Manual machines can be adjusted by turning the knob at the back of the machine, and automatic machines can be adjusted by two knobs at the side. After adjusting the position, you can punch holes.

Step 2-Manual hot riveting binding

After drilling the hole, the riveting pipe will automatically cut off and fall into the nozzle groove. Just put the cut rivet tube into the hole, then translate it to the left rivet head, insert the centering shaft into the rivet tube, and then press the handle, which can only stay for 2-3 seconds. The centering shaft of the manual binding machine must have no clearance with the silver knob on it.

Press the handle

Matters needing attention in riveting of Yilijia binding machine:

A, before drilling, remove pins, staples and other metal objects.

B, please confirm that the glue has dried out before binding, and binding before the glue dries out will affect the service life of the drilling tool.

C. If you are not skilled in using it, try not to punch holes in the original holes. When binding, you should reserve a certain margin, and don't lean too far.

D, use manual binding machine should pay attention to the length of the knife.