Preparation materials of twelve pieces of paper by lotus folding method.

Three different colors. You need four rectangular ones for each color.

Two of them are petals. The other is used to make leaves.

In addition, prepare a rubber band and make petals 1: 0 1 first. Fold them in half. Open it and turn to the other side.

02.4 angle folded. 03. Fold both sides in half.

04. Then, fold it according to line 0 1. 05. Three other pieces of paper of the same color are folded in the same way.

Petal 2: Very simple. Fold in the same way as petals 1. Then, make leaves. Slightly different.

0 1. Like petals, fold in half. 02. Unlike petals, you don't have to turn to the other side this time.

Open it and fold all four corners directly. 03. Fold both sides in half.

04. Then, fold it according to line 0 1. 05. The other three pieces of the same color are also folded in the same way. Lotus production: 0 1. Fold three colors.

The bottom layer is leaves. The middle layer is the outer petal.

The top layer is stamens. 02. The other three sheets of paper are stacked in the same way.

03. Then put 4 stacks together and tie them together with rubber bands. 04. Try to pull the two stacks on the left together and the two stacks on the right together.

05. Slowly, push the stamen up. 06. Again, slowly push the petals up. 07. Then, as for the leaves, press them down gently.

You're finished. See the link jingyan.baidu/album/19192ad85b4c44e 53e5707aa for the chart.

How to fold lotus ingots with tin foil

Lotus ingot is the name of ingot.

The method of folding lotus root ingots with tin foil: 0 1 First, prepare a piece of tin foil with a length-width ratio of 3:2, so that it will look better when folded. Then fold the tin foil in half along the long side, paying attention to the silver edge outside.

Fold the folded edge up by about one third. Fold the last step in half and then fold it in half to make it a broken line.

05 and then fold it in half. Fold the square obtained in the previous step upward at an angle.

Same as above, another corner. As shown in the figure below, an isosceles trapezoid is obtained.

Hold the two corners with both hands, and blow air from the bottom to the top with your mouth, so that the inside of the trapezoid expands and the shape of the ingot is obtained. 10 finally, the gold ingot was folded.

Extended data:

Lotus ingot folding method: 1. Take a piece of paper with an aspect ratio of A4, and fold it three times. 2. Open the top fold and fold the other end of the paper to align.

3. Fold the four corners into a triangle. 4, folded in half, that is, into a boat shape.

5. Pick it up and blow into the gap at the bottom. 6. A rich ingot is ready.

.

How to fold the lotus?

Step 1 to fold a piece of lotus paper. First, fold the corner in half.

2. Fold the four corners to the middle of the paper. 3. Continue to fold the newly formed four corners to the midpoint.

4. Still fold the four corners to the key points. 5. At this time, turn the origami over and fold it from the corner to the midpoint again.

6. Carefully fold the four corners inward according to the dotted line. 7. This step needs to be very slow to prevent the paper from being torn. Fold the small square paper behind each corner to form petals.

8. There is also a piece of paper that can be turned over on the back of each side. Turn it over. 9. Finally, turn a piece of paper corresponding to each petal to the front 10. As long as you have patience, you can easily make this origami lotus! .

How to fold the lotus seat with paper?

The most important thing of paper lotus is this folding, which is the beginning of lotus petals and the basic prototype of lotus. What we should pay attention to here is the face without words, that is, the crease will fall on the part with words. Why should we emphasize this point in particular? Because the old paper is not a square, it belongs to a somewhat positive rectangle, and the part with words is usually wider (that is, from the perspective of the two lines "pulling out the root of karma and getting the pure land of Dalani"), now I will start with the lotus petal method: first fold it in half, then take the paper next to it and fold it parallel to the straight line, pay attention to what is marked on the other picture, and leave a little gap for subsequent processing.

The other side is also folded like this, as shown in the above picture. Then take the corners of the four sides and aim at the edge of the paper that has just been folded in, as shown on the right.

Then take the two sides of the paper and align it with the edge of the paper that was folded in at the beginning, as shown on the right, thus completing the basic lotus petal paper model. There are gaps because of the last two folds. If there are no gaps at the beginning, when you fold here, you will find that the paper meat folded in on both sides collapses together because of the thickness of the paper, and then it will be easily damaged or difficult to fold when you want to turn it into a lotus petal.

Then, fold the folded pattern of paper lotus petals together as shown in the left picture, and make 4, 5, 4 and 5 into a box, and tie them with rubber bands (that is, after folding 4, 5 are next to each other? Then a stack of four, the last stack of five). After that, it is expanded into an 8-angle shape as shown in the left picture, and a piece is turned vertically upwards, as shown in the right picture.

Rotate the other petals until the eighth corner refers to the petal on the left, as shown in the right. The lower flower half only needs to be gently pressed with the thumb to make its tip tilt as shown in the left picture, and the finished flower half is shown in the right picture.

In this way, a basic lotus is completed. As for why it is a foundation, you will know in the end. Then, make another most important part of the paper lotus, the lotus seat. Do you remember the most basic folding? Stack 36 folded sheets of paper together and tie them with red rope or red plastic rope to complete the stacking as shown in the above picture, which is the foundation of the lotus seat.

Take the upper corner, aim at the position where the red line is tied, aim the edge at the "paper corner", bend the triangle as shown in the left picture, and then turn the triangle down. Be careful not to press down the hypotenuse of the curved triangle too hard, otherwise it will make the lotus seat look ugly and plump. Next, take off a corner, aim it at the red line and the edge in the same way, bend a triangle in a different direction from that just now, and then turn it down, as shown in the left picture (don't look at me, it seems to be very hard, in fact, I just put my hand on it).

After seven repetitions, as shown on the left, half will expand to the right like this. How's it going? Did the shape come out? Then try to keep turning and turning, and it will turn to the left. When viewed from above, it will turn to the right. Of course, when you turn it, it will inevitably cause its shape to be out of round, so you must decorate it a little after turning it. As for why the red line should be aligned with the edge and the corner, it is to prevent the corner from running out. Maybe you will say, it's best to insert it in the red line, so it won't stand out or be faster. Believe me, when you turn to the other side, you won't be able to turn around until you see a sharp thing protruding over there, and the seat will be smaller. If you turn the lotus outside a little, you will be top-heavy. After that, I picked up the newly made lotus and passed under it. Pay attention to my black handwriting. Some people may say, just pull the line, but according to my experience, unless you don't care about the lotus with a little opening on both sides, or you are over 500 years old, the line will be blurred when you pass through it. Otherwise, Wang Ben strongly recommends that you don't pull out the thread, because it is difficult to change it back to its original beauty.

Then I tied a hard knot, as shown above. Finally, decorate the petals, and the way of decoration is also very simple, that is, give her eversion! Then turn the center of the edge of the face over and fold it with a small crease, and you can complete such a beautiful lotus to the left! .

How to fold the lotus?

Tools/Raw Materials Rectangular Paper Ring Method/Steps 1 First, prepare the paper we want to use.

Now let's start folding. First, we need to take a piece of paper and fold its long side in half.

2. Fold and open, and both sides of corner 3 are folded towards the center. After folding, three pinks and one green are stacked together in the same way. The stacking order is: the bottom is green, the back is up, and then there are three pinks, the front is the side that has just been stacked, and the back is green, as shown in the figure below. Now it's stacked face up. Fold the folded four pieces (a group) together. Green is the innermost pair in the group. If it is made into a group, it can be pinned with paper clips or folded at one time and then assembled together. Ha _ all made into four groups (three pink and one green in each group, a total of 12 pink and four green ^_^b). Take off the paper clip and tie the four groups of aligned edges in the middle with a line. This is the side. Fold the four groups in half and pull them away from the binding line to make them into eight groups. Pull up the first layer. Pay attention to pull one every other layer, four on each layer. Each piece overlaps and crosses each other. Pull up the second, third and fourth floors, the fifth and sixth floors. At this time, all the pink has been pulled up, leaving only the green part untreated. Pull up the green one by one. Be careful not to pull too hard. When pulling the petals upward, you must carefully pull them toward the center. Don't pull them forcibly, or there will be a hole in the center, which is not conducive to beauty.