However, there are still some details in the design of robot shaving, so it is not an imitation of 100.

So it's still artificial and delicious, but it can be artificial with a little modification.

There is something wrong with the left and right C code planes, but the upper and lower C code planes are slightly better.

Problems with noodle cutting machine:

Reduce the shaving stroke, not too long, just for efficiency. Just cut the trip.

Some machines are too thin, others can.

The feed is too straight, so it should be inclined at 45 degrees.

Seen from the cross section:

Straight into the slicer, the cross section basically conforms to the wing cross section, but the triangular structure is not prominent. The right corner of the cutting part is sharp enough to meet the standard, but the left corner is too sharp because it is straight in, and there is no groove on the left side, which is different from the artificial surface.

Hand cutting is not pure cutting, because it is a 45-degree feed and has the effect of pulling torque, so the right blade is sharp, the left blade has a slight notch (pulling off), and the left triangular edge forms a groove due to pulling.

The difference is that the serrated notch on the left side and the groove on the left side of the microstructure can be dipped in more marinade, and the taste is better and richer.

Non-c pendulum surface, I pendulum surface is better. The existing double knife machine meets the requirements (but the blade length and angle do not meet the requirements)

The feed should be 45 degrees instead of horizontal feed. None of the machines now have it, just fine-tune.

It is best to walk under a curved surface, and the mechanical requirements are complicated, so no one does it. Under the curved surface, Daoxiao Noodles is thin at both ends and thick in the middle, which is different before and after. This is the third difference from manual work.

The advantages of handmade noodles are the second, the third and the essence. It is also lacking in machinery. Machines can actually do it, but they need more subtle design.