How to take out the knife mesh: open the green locks on both sides after power off, remove the top cover and push rod, and then grab the edge of the knife mesh with five fingers apart and lift up a little to take down the knife mesh, then remove the juice collection tray according to the labeling of the body, and then wash and dry it with warm and cold water piece by piece.
1, master the name of each part, so that the assembly is convenient, the first step is to fix the host, according to the counterclockwise direction to turn the locking knob, the suction cup and the countertop suction firm.
2, the second step, the bottom of the barrel buckle into the host slot, push forward until you can hear the "click" sound, which means that the top.
3, the third step, the pop-up ring escaped into the root of the spiral extrusion rod.
4, the fourth step, the assembled spiral extrusion rod into the barrel.
5, step 5, press the sealing ring into the bottom of the juice head nut, and make sure it has been pressed flat, if it is not pressed flat, it may lead to air leakage, which is not good.
6, step six, turn the juice head and barrel tightly in the counterclockwise direction
7, step seven, install the rocker, manual juicer, no rocker is equivalent to a car without a key, so be sure to install it correctly.
8, step 8, put the push rod, installation is complete, so you can start using the juice.