2. Move the float down about 20-30 cm, which is longer than the float, then cut off a little lead skin and throw it at the fishing spot. If the float is completely submerged, continue to cut the lead skin. Don't worry, you must cut it bit by bit until the float is above the water. In general, I will adjust it to four eyes first, and the soft tail drift can be two or three eyes. This is an adjustment.
Third, set up fishing eyes next. First move the float upwards about 20 cm, then throw the bait to the fishing point and press the waterline. Don't worry. If the float sinks into the water, it means that the waterline is not long enough, then move the float upward once 10 cm or about 5 cm. Continue to hang the bait and throw the rod until the float comes out of the water again to the original adjustment, and then continue to move the float up and down for a short distance, usually one eye or half an eye. According to the actual situation, determine the final number of fishing eyes, that is, fishing eyes.
One thing to note is that the adjustment should be done slowly. You can also roughly adjust the float at home or elsewhere. After you arrive at the fishing ground, because the density of water in each place is different, you can adjust it slightly according to the actual situation.
In addition, the buoy itself absorbs water, and the difference between floats with different qualities lies in the different speed of absorbing water. Floating after absorbing water will change the adjustment of eyes, and of course the display of fishing season will be inaccurate. You must know the water absorption characteristics of the buoy you use, and if necessary, after fishing for a period of time, pull the buoy to half water for verification. Only in this way can it play a real role.