How to make creative vases with mineral water bottles
The first type: mineral water bottles make beautiful vases.
When you see this vase in the picture above, you will be amazed at its beauty. Do you really want to have such a vase on your desk? But can you think of how it was made? In fact, it's just a coke bottle and mineral water bottle that we usually abandon, and then it's made by a very simple transformation. Do you really want to try it? Then let's take the steps of making diy creative vases of mineral water bottles with 63diy. I believe you can make such beautiful vases after reading them ~
You have to prepare some materials first: plastic bottles and scissors.
1, first find a 500ml beverage bottle.
2. Cut from the top of the bottle.
3. Cut it into two pieces, leaving the lower part.
4. Then cut it vertically until it reaches the position of the pattern.
5. The width of the cut strips should be the same.
6. Cut the whole week of the bottle into thin strips.
7. Start weaving flowers now.
8. Buckle the bottle down and let all the cut strips unfold.
9, flattening, so that when the bottle is placed, the thin strip will no longer retract and rebound.
1 1, tuck in article 1 as shown in the figure.
12. Use the same method to omit Article 2.
13. Re-insert Article 3.
14, this is a panoramic view with three articles tucked in.
15. Tuck all the strips in turn in the same way.
16, the ending method is the same.
17, it's finished after all the thin strips are tucked in. It's very simple.
18, show a overlooking effect.
19, you can arrange flowers.
The second type: mineral water bottles are homemade to make hot flower hollowed-out vases.
Materials needed for production: beverage bottle, electric soldering iron, painting, flowers.
Production steps:
1, turn on the soldering iron and heat it, and iron the hole on the bottle body.
2, hot hole can be arbitrary, on the side of the bottle, making a lace.
How to make a hot flower hollow vase for beverage bottles
3. Connect the hot holes on the bottle body with an electric soldering iron, and cut off the whole top half of the bottle mouth, so that the edge of the vase can have irregular shapes.
4. The vase body consists of irregular hot holes to form a personalized hollow pattern.
How to make a hot flower hollow vase for beverage bottles
5. Paint the bottle evenly with spray paint.
6. Finally, fill the vase with water, insert fresh illustrations and green leaves, and finish!
The third kind: mineral water bottles make a fashion vase.
Material preparation: plastic bottles, dyes, brushes and adhesive tapes.
Simple household hand-made plastic bottles turn waste into treasure. The detailed steps of simple vases are as follows:
Stick the tape on the plastic bottle as shown in the figure, then apply dye, and then tear off the tape when the dye is dry, and a simple and fashionable vase will be made.
The fourth method: making vases with hemp rope and glass bottles, and tying the vases by hand.
Make hanging vases with hemp rope and glass bottles. DIY is a very simple waste. Just tie the glass bottles with hemp rope. Let's learn. .
Tie it from the bottle mouth.
Tie a rope ring around the neck of the glass bottle first.
Then tie the hemp rope with the rope ring.
Illustration of knitting mode.
The tying ropes on the bottle body are all the same.
Tie the bottom of the bottle.
After tying the bottle, you should leave a pigtail at the bottom of the bottle.
Finally, tie a lanyard at the mouth of the bottle.
Simple and beautiful hanging vases are ready. .