1. First, divide the paper into eight equal parts, and then fold it.

2. Then divide this paper into 16 equal parts. Make a wavy crease. Do it.

3. Fold the lower right corner like the second floor, as shown in the figure.

4. After that, open the crease, then fold the first layer and the second layer backwards, starting from the third layer, and use the third step method again.

5. Other layers do the same steps according to the above method until they are completely opened.

6. After that, open the crease in the lower right corner, then die and turn back to the first and second floors. How to also make the corresponding crease.

7. After the opposite foot gets the same crease in the same way, the paper will have the following crease after opening.

8. The grain depot will collect paper according to the traces of creases until all creases are folded horizontally and vertically.

9. Then take out the second piece of paper and follow the above steps.

10. Connect the edges of two pieces of paper with double-sided tape, and then complete the lantern.

The second method

Materials: cardboard, paper cutter, ruler, pencil, double-sided tape, string.

Prepare a rectangular red cardboard (I use an expired old calendar card).

2. Leave 0.5~ 1.0cm on both sides of the cardboard, draw several parallel lines equally, and then cut them with a paper cutter.

3. Roll it into an arc.

4. To paste, first cut the scraps into thin strips for ears, and then paste the thread.

Ah! Beautiful little lanterns are ready.

Required materials, punching machine, glue, iron wire, decorative ribbon, colored paper, scissors, etc.

Fold a piece of colored paper in half.

Draw a vertical line on the material with a ruler, paying attention to drawing from one side of the seal. Don't draw the vertical line on it, and then cut it off along the edge with scissors.

Cut a row of vertical lines, unfold them and roll them into a tube, as shown in the figure.

Roll it up and fix it along the edge of the big paper tube, as shown in the figure, punch holes evenly on the upper and lower edges with a punch.

Finally, the upper and lower ends are decorated with decorative ribbons, and the upper ends are connected with iron wires. It's good to pick up the stick or carry it directly!