1, click Setup.
Click "setup.exe" to enter the installation interface, and a prompt interface will pop up, which will not affect the software installation. Just click OK.
2. Select the installation type.
In the interface of the installation manager, select the installation type, click "Single Machine Installation" on this computer, and then click "Next" on the arrow in the lower right corner.
3. Fill in the serial number.
In the interface of filling in the serial number, if it has been installed before, you can log in and the serial number will automatically appear. Click "Next".
4. Read the warning message.
System and check warning, the software installer automatically checks the system information of the computer, reads it and directly clicks "Next".
5. Select the installation location.
In the interface, click "Change" to change the product content, the installation location of the software and the selection of toolbox/special hole wizard. Just set it according to your own needs. The recommended installation location is disk D. Select I accept the SolidWorks terms and click Install Now.
6. Wait for the installation progress.
Enter the installation interface, wait for the installation progress bar to reach 100%, and the installation time is about 30 minutes to 1 hour.
7. Complete the installation.
After the installation progress is completed, the installation completion prompt interface will pop up. Select "No, thank you" in the improvement plan option, and then click "Finish" to exit the installation program, and the installation is complete.
SolidWorks has made it clear in the official Weibo that genuine SolidWorks software purchased through formal channels will not contain backdoor problems, and people who use pirated SolidWorks software can't even give an answer to the correctness of the software. So how to avoid backdoor problems?