first, take a square piece of paper and put it on the table with its back side up. Note that the square paper should not be too small, or you will find that you can't continue and give up all your previous efforts. The side length of the paper is not less than the length of the index finger. Let's first fold the square paper in half along the two diagonal lines before opening it, then fold it in two directions and open it separately. You will find that the square paper is now divided into eight parts on average.

Next, please hold any opposite fold line of the square paper with both hands and gently squeeze it toward the middle. At this time, the other side folding line will be slightly tilted forward and backward. Then, press hard towards the middle along the seal of the opposite fold line and form a cross. Then, the two sides are printed and flattened according to the diagonal lines folded in advance. What must appear in front of you now is a two-layer diamond.

Then, fold the center line of the "double diamond" in the opposite direction, that is, turn the diamond one by one-the part just inside has been turned out now. After turning, fold the four corners of the "double diamond" inward along the center line. Note here that the corners must be aligned when folding, otherwise be careful that the mouth and tail of the crane are not sharp at the end!

I believe that the origami in your hand must be a "double ice cream cylinder" at this time, so please fold the ice cream part of the "cylinder" in any direction once, in order to leave a seal. Next, open the "double ice cream cylinder" and lift any corner to pull it up. Flatten again. A slender diamond is "freshly baked". Repeat the same steps on the other side. Don't use too much force when folding, and carefully align and adjust the corners.

after flattening, push the "double-layered slender diamond" upward from two small corners of one end that can be separated in the middle, until it can't be pushed any more, and then flatten it gently. These two upturned horns are the forerunners and tails of the crane. The other two "towering" big horns, needless to say, must be the two wings of a small crane.

now, you're done. A beautiful and profound paper crane will be folded. We can also fold the "predecessor" of the small crane back to form a smaller corner as its small head. I also often like to gently roll the wings of the crane with a thin pen to make it more three-dimensional

How about this little paper crane made by yourself, and your heart? Steps for making children's Kongming Lantern origami

See if this one is satisfactory? Is a real shooting tutorial, Baidu disk link:: pan.baidu./s/1mg6pDI hand-made origami-four-corner windmill gift box lid

Prepare square paper.

1

Fold the paper diagonally, unfold it ...

2

Fold it and unfold it, fold the lower corner to the upper side ...

3

Fold it and unfold it again, fold the right corner to the center ...

4

Unfold the paper and fold the left corner.

6

Fold from top to bottom.

7

Make a crease and unfold it. Turn the right corner backward

As shown in the figure, align and fold it to the bottom of the upper triangle.

8

Fold the right corner back after folding.

9

Open the corner on the back, and the edge of the paper will stand up, as shown below ...

1

Fold out four box corners in the same way.

11

Combine the corners of the box to complete the work.

12

For friends who want to make a gift box cover, please refer to zhile123, "... What gifts to give for Mother's Day?"

You can fold some carnations for your mother, or buy her a beautiful dress that she is usually reluctant to buy.

No matter what you send, what she likes is your sincerity and your filial piety. Therefore, as long as you help your mother do more housework and help her reduce the burden, she will naturally see your sincerity. Happy holidays to all mothers in the world! How to make origami starfish, how to make origami starfish by hand

Tools/materials: colored paper, scissors, glue Steps: 1. First, fold a small piece of colored paper in half, simply cut out a five-pointed star, then spread out and fold each corner in half once, and cut a small line in the middle of each corner with scissors. 2. Turn it into a small triangle along these cut lines.

how to make origami fish

how to make origami fish

1. First, prepare a square piece of paper, which is a common basic material in origami. Fold the top corner of the square paper to the bottom corner.

2. Then fold the top corner of the triangle on the upper surface upward along the direction indicated by the arrow and the position of the new crease.

3. At this time, fold the top corner of the triangle on the lower surface diagonally to the right along the direction indicated by the arrow and the position where the crease is located.

4. Then fold the top corner down to the left along the position where the arrow and the new crease are located.

5. At this time, the left top corner can be folded to the right along the position of arrow and crease.

6. Fold the newly formed upward corner along the direction indicated by the arrow and the lower left where the crease is located.

7. Fold back the top corner of the right side of the original triangle.

8. Turn the origami model over completely.

9. Finally, draw your favorite cute eyes with a brush, and make a simple origami fish! PS How to make origami characters

: jingyan. Baidu./article/E4D8FFDCEE44CD2F6D3. Find out the detailed method of making origami all over the sky and the requirements of paper

Go to Paper Art. . . . How to make

colored cardboard with shredded origami, the softer kind, cut to a suitable length, and pay attention to leave a good position when pasting, otherwise it won't stick, use liquid glue, which I haven't done before. Seeking video: making folding fans out of paper

Material of fan bones 27-7-2 13:8 Generally speaking, the advantages and disadvantages of folding fans lie in two aspects: fan bones and fan faces. For example, what material is the fan bone, what carving or special technology is there, and whether it stretches well; Whether the paper material of the fan is still good or not, what's special about it? For example, in the Ming Dynasty, golden noodles prevailed, and in the Qing Dynasty, plain colors and gauze-sandwiched fans were advocated. Folding fans are usually folded up. Most people must look at the fan bones first, and the pros and cons of the fan bones are the first person. Any fan with a good handle, the fan bones account for a lot of weight. According to the memories of some old people in cultural relics shops, some people with status, one in the hand and one in the sleeve, are props of status, and after these people sit down, they often exchange folding fans with each other to enjoy tasting. If the fan bone is strange and the fan is from a celebrity, it will be praised. Therefore, some literati and even bureaucrats at that time never dared to use inferior fans easily, so as not to be looked down upon. At that time, there was a special fan village, which operated all kinds of fans and provided a variety of services, which were left to the following articles. It is precisely because the fan bone is a facade of the folding fan, and it is the first object that people appreciate and evaluate. Therefore, the production of the fan bone has gradually improved with the times since the Ming Dynasty. From the material point of view, there must be more bamboo. With the improvement of people's appreciation and taste, only bamboo can't be satisfied, so some high-grade rare materials join the ranks of fans. In fact, before the folding fan appeared, the handle decoration of the round fan and the tail fan began to have a luxurious style. For example, the tail fan is generally made of bamboo and wood, and this material can be found everywhere. But later, the fans used by princes and nobles had various handles, such as jade handles, rhinoceros horn handles, ivory handles, tortoise shell handles, gold-plated handles, etc. The materials used in such handles can be said to have reached the peak. However, the luxury and elegance of the folding fan bones since the Ming and Qing Dynasties can not only keep pace with it, but also greatly surpass the past in terms of craftsmanship. First of all, folding fan ribs can be said to include all kinds of bamboo in the world in terms of bamboo use, such as Bambusa bambusa, Bambusa bambusa, Xiangfeizhu, Plum Bamboo, Peach Silk Bamboo, Sesame Bamboo and Fodor Bamboo. In the world of fan bones, few kinds of bamboo are left out. In wood, pine and cypress were used at first, and later, rosewood, sandalwood, mahogany, ebony, boxwood, nanmu and chicken wing wood, and any good wood was used for fan bones. In addition, rare ivory, animal bones, horns, hawksbill, jade, gold, silver and copper are also used in fan bones. It can be said that a small fan bone actually covers the whole world of bamboo and wood materials. That's not to mention, the fan bone uses all the means of carving technology. On the basis of China's calligraphy and painting, folk auspicious patterns, it adopts various methods to make this fan bone, which is not full of feet in length and less than inches in width, present a dazzling main artistic color and reflect the art world with unique charm. Bamboo is the first choice for fan bones, and there are many kinds of bamboo involved in fan bones. The selection should be introduced as follows: Xiangfeizhu pays attention to his own spots when using Xiangfeizhu as fan bones. Xiangfeizhu is also called "Spotted Bamboo", "Tears Bamboo" and "Xiangzhu". The name of xiangfeizhu comes from "Shuo Yi Ji". Legend has it that Yao Chan was located after Shun, and Emperor Yao had two daughters, one named E Huang and the other named Nv Ying, both of whom were married to Shun. Shun southern tour, died in Cangwu, E Huang, Nv Ying heard the news and stood on the Xiangjiang River bank crying, tears spilled on the bamboo and became spots. In the bamboo spectrum of qunfangpu; "Spotted bamboo, that is, Wu said Xiang Feizhu. Its spots are like tears. " Liu Yuxi has "Song of the Thai Mother", which says: "How to shed these thousands of tears on the Xiangjiang River?" Xiangfeizhu is a good material for fan bones, and its own spots are the most natural decoration. It is said that when calculating the value of many xiangfei bamboos, they should be weighed on the balance and equal to the value of gold. Xiangfeizhu is a kind of scattered bamboo in the west. The bamboo pole is 5 meters to 15 meters high, the bamboo wall is medium thick, and the internodes are about 3 centimeters long, which is just for fan bones. However, the bamboo office on xiangfei bamboo is very particular: the bamboo spots on it are natural, and this kind of spots is natural; Also, when Bambusa bambusa was born, the money was sealed on the stage. When Bambusa bambusa became a stage flower, the purple halo on the bamboo refuted the love. There are also scalding on ordinary bamboo with fire, so that the bamboo skin is burnt into spots in the region. The above three are better than the former two. Naturally occurring spots vary in size and distribution, and those with many spots and clear spots are the best products. However, there are also amazing and excellent people. The author once saw a fan bone of Xiangfei bamboo, with an irregular big spot on it and a small spot below it. Although there are few spots, it is more novel and lovely. As for whether it is a scalding spot, it is generally known at a glance. The scalding spots are regular and unnatural. According to an old cultural relic pedestrian, a trick is to close your eyes and touch with your hands, and touch the burned place with your hands. If it is flat, it is hot ... 9. When you turn on the phone, I will say hello to you, do everything smoothly, live a better life, and get lucky every day in the lottery period. You will win in the poker game, and your taste will be better. The more you live, the younger you will be.