Current location - Recipe Complete Network - Healthy recipes - What happens when a magnet is placed in magnetic mud?
What happens when a magnet is placed in magnetic mud?
The magnetic mud becomes sticky and slowly moves to the magnet and adheres to it. After a few minutes or so, the magnet was completely wrapped. The same is true of circular magnets. Magnetic mud can also be adsorbed on the magnet, and the gap in the middle is completely unbonded. After the experimenter took the sticky magnetic mud out of the magnet, the magnetic mud continued to collapse on the table, and the magnetic mud was directly adsorbed on the magnet until the magnet was completely immersed in it.

Even if a plate is placed under the magnet, the magnetic mud at a certain distance from the magnet will pass through the plate and surround the magnet. When we move the magnet on the magnetic mud, we can clearly see that the magnetic mud will be adsorbed where the magnet passes, which looks like the magnetic mud moves with the magnet. I wouldn't believe anything unless I saw it with my own eyes, because such a small magnet can have such great magic.

Magnetic clay, that is, magnetic plasticine, is a magnetic toy. Generally, it is made by mixing plasticine and ferroferric oxide powder to prepare a well-ventilated workplace, because iron oxide black is a very fine powder, which does not feel good after inhalation. Remember to wear gloves and masks before you start. Take out the plasticine, heat it in your hand for a while, then stretch it into thin slices and put it on the pre-laid newspaper.

For such a big plasticine, you should use a tablespoon of iron oxide black, about 15 ml. You can roughly mix iron oxide black for your plasticine according to this ratio. Carefully put the black iron oxide powder in the middle of the plasticine board, and gently combine the edges of the plasticine to prevent the powder from scattering. Gently rubbing powder into plasticine will produce a lot of dust. After a minute of massage, plasticine will lose its original color and turn black. After blackening, knead for 3 ~ 4 minutes, and the magnetic plasticine is finished.

Let's call it a day. If you have other different ideas and opinions, you can share your personal opinions in the comments section below. Those who like me can pay attention to it. Finally, I wish you all the best.