It is very simple to make a simple oil seal by cutting out a disc smaller than the circle on the edge of the bread barrel shaft, punch a hole in the middle with the same diameter as the shaft of the mixing blade, and cut the disc Use a round iron rod to roll out one edge to hold the oil-absorbing round piece of cloth. The round piece of cloth is a little smaller than the oil seal cover. I think it would be good to cut a round piece of cloth from the cloth cover that comes with buying a mobile phone. The first advantage is that it absorbs oil. Second, it is strong and does not shed hair. Cut a hole in the middle of the piece of cloth that is as large as the diameter of the shaft. Put the piece of cloth into the root of the shaft and cover it with the oil seal made from the bottom of the Lulu can. OK, the job is done! Clean the cloth pad with degreasing dish soap two or three times, throw it away after a while, and replace it with a new one! As shown in the picture:

Note: To drill holes in the bottom of the Lulu tank, if you don’t have a drill, use 8mm bolts and hammer them on the nuts. Which tank bottom is the small circle between the bolts and the nuts? Film, punching a hole is like playing!

Bread bucket

Use the bottom of the Lulu can to cut a circle

Use an iron rod to roll a small raised edge on the edge of the cut circle< /p>

Put the round piece of cloth used to absorb oil under the round piece cut out of the bottom and you are done.

OK, since the bread machine barrel leaked oil, I went to a certain store and saw that a new bread barrel cost more than 100 yuan. I saw that it was in short supply, so I had to think about how to overcome it and make my own. I have been using this simple oil seal. I have changed the oil-absorbing cloth several times. I have been using it for more than a year and it is completely normal. After making bread, I peel off the simple oil seal and you will see that a lot of black color has been absorbed into the round cloth. There is something that looks like grease. After rubbing it with dish soap, rinse it with water into a small bowl. It turns out to be light black water. There are black irregular and granular substances of different sizes that look like grease floating on the water. It should be a leak. The lubricating oil and the steel shaft are running and grinding to form a grease containing very fine iron filings, so it is black. (If you ask why the oil is black, you will understand why the oil in the gearbox is black.) Use your fingers to apply it on the belly of your fingers, which means that the homemade oil seal has completely blocked the oil leakage. Very easy to use. Doesn't cost a penny! I am so angry at the unscrupulous seller who purchased the bread bucket for RMB 30 and sold it for RMB 100. Think about it, the whole bread machine only costs three or four hundred yuan! Ha ha!