Current location - Recipe Complete Network - Pregnant women's recipes - How to adjust 4 fishing 2 drift
How to adjust 4 fishing 2 drift

The techniques of adjusting the drift of 4 fishing 2 are as follows:

Step 1:? Lead to find the bottom:

Drifting to find the bottom is a crucial part of the whole process of drifting, which is to help anglers grasp the depth of the fishing spot is the most convenient and more accurate method.

The lead on the lead seat can make the float smooth and light sinking lead, do not need to roll too much, too much lead is too heavy, in the casting line due to inertia will form a diagonal angle underwater, will be greater than the actual depth of the water, to the angler caused by the cognitive error. Therefore, you should only roll as much lead as you need to make the float sink lightly.

Step 2: Pull down the float beyond the ? Subline length:

After finding the bottom, pull the float down beyond the length of the subline. This length should only slightly exceed the length of the subline, there is no need to exceed it too much. For example, if the length of the subline is 20 centimeters, then pull down the float 25-30 centimeters.

Step 3: Cut the lead so that the float is four meters above the surface:

After pulling down the float by a subline length, the next step is to cut the lead so that the float is finally four meters above the surface. At this point, the four "tuning eyes" of the four-fishing-two are set.

Step 4: Hang the bait and weigh:

Hanging the bait and weighing is the most critical step in the whole process of drift regulation. Especially for novice anglers, weighing the bait directly determines the accuracy of the tuning. As long as this step has been mastered, then "adjusting a few fishing a few" will not have the problem of inaccurate tuning.

There are two stages to bait weighing: the first stage is single bait weighing; the second stage is double bait weighing.

Step 5: Pull up the float to the desired fishing aim:

After the completion of the double bait weighing step, we need to adjust the final "fishing aim", that is to say, the "fishing aim" in the "adjusting four fishing two". Two eyes. The specific operation is: pull up the floating rod into the water (this operation needs to be repeated), until the float exposed to the surface of the water a little more than two eyes or two and a half eyes, at this time the completion of the entire "tune four fishing two" of all the steps.